CFEF210CS5 Frigidaire Range - Parts

This part is a levelling leg and it is used in conjunction with your range. The function of this part is to supply stability and support to your appliance. This part is adjustable to allow you to tailor each leg to meet your levelled cooking needs. A range typically uses four of these parts, and this model is sold individually. This part ...Read moremeasures to be just over a square inch wide, and almost two inches high. The body of this part resembles a screw and is made of metal. The bottom of the leg is black, flat, and made of plastic.

This is a bulb clip, also known as a sensor clip or bulb holder, which is designed to hold the thermostat bulb in place within the interior of various models of ovens. This clip is made of metal, measures approximately 1-inch in length and is a genuine OEM part, but is sold by itself and without the thermostat itself. The thermostat bulb,...Read more also known as a capillary thermostat, is used to measure the interior temperature of the oven during operation, and this clip secures it. If you notice your oven heats unevenly, too little or too much, this clip may be rusted, broken or damaged and causing the thermostat bulb to not detect the internal temperature properly. To replace this clip, you will likely need your user manual and a screwdriver and/or wrench. You will first need to disconnect your oven from the wall outlet and remove it from the wall. Use your user manual to locate the thermostat and use your screwdriver and/or wrench to remove the panel covering it. Here, you can likely replace the old clip with the new one, and then reassemble your oven.

This storage drawer roller allows the drawer to slide in and out smoothly while maintaining proper alignment. Designed for reliable movement and stability, it is an effective replacement when drawers bind, tilt, or become difficult to open and close.

This switch controls the stove top surface burner.

This genuine OEM 6-inch electric surface burner element is designed to provide reliable heat for smaller cooking areas on your range or cooktop. Featuring a durable coil design with plug-in terminals, it delivers consistent heating and supports even cooking performance. Ideal for replacing a worn or non-functioning element, it helps resto...Read morere proper operation and efficiency. For safe installation, always disconnect power and handle the element with care.

This surface element control switch is designed to regulate the heat level of a small 6-inch electric surface burner, allowing users to smoothly adjust cooking temperatures from low to high. By controlling the amount of power sent to the heating element, it helps deliver consistent and responsive heat for everyday cooking tasks. Rated for...Read more 240 volts and capable of handling elements within the 1296 to 1680 watt range, this switch is commonly replaced when a burner will not heat, fails to turn on, or remains stuck at one temperature. As a direct-fit replacement, it restores proper burner control and safe, reliable operation of the cooktop.