BM903511 (090930234) Homelite Generator - Parts

It is an authentic OEM component which is made for Homelite and Ryobi generators. The receptacle is the part that a power cord of your equipment or appliance would connect to draw power from the generator. Use an extension cord intended for outdoor use with a 3-pole receptacle and a 3-prong plug at opposite ends to ensure continuity of th...Read moree ground protection from the generator to the appliance. It is an identical replacement for a faulty or a missing 120-volt duplex receptacle that was installed on a new unit. Refer to the diagrams of your model for the exact location and the correct installation of the new component. You will need a screwdriver to take apart the housing when performing this repair.

This vapor vent, also known as a vent valve or vent cap, is supplied by the original manufacturer for use with generators. It is designed to provide ventilation for the fuel tank by allowing air to enter and leave the tank as necessary. The vent prevents pressure from building up in the tank and interfering with the flow of fuel. Over tim...Read moree the vent may become clogged, or damaged leading to hard starting, fuel leakage, stalling, and the release of harmful gases into the atmosphere. It is recommended to inspect the vent before each use and replace any blocked vent promptly. To complete this repair, remove the faulty vent from the fuel tank and clean the mounting area. Thread the new vent on to the tank and ensure it is locked in place.

This is a genuine manufacturer-sourced component that is specially designed for use with Ryobi, Ridgid and Homelite equipment. It is an identical replacement for a missing or faulty switch that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and applicati...Read moreon of this item. Keep in mind this high-quality plastic body switch is sold individually.

This is an original part from Homelite. The lock nut (m8 x 1-1/4 mm) is compatible with many pressure washers, and is sold individually. The metal lock nut helps to secure various components of the pressure washer. A wrench, hex key and screwdriver are often needed for the installation.

Gasketcylinder head