AWM4 Amana Washer - Parts

This inlet hose washer, also known as a high pressure inlet hose washer, is used in washing machines, refrigerators, freezers, and dishwashers. The function of this part is to create a watertight seal in the appliance. If your gasket gets dry and brittle over time it will start to crack and will lose its function. In this case, it is impo...Read morertant to replace it. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance. As a safety precaution, remember to unplug your washer from the power source before beginning.

This triangular main tub bearing assembly is five inches long. It is made of metal.

This valve has two ports for water to enter. This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

Bearing only.

These springs are sold individually and usually require a total of 7 per appliance.

This washing machine drive bell and seal kit comes with a seal, a plug, a shoulder screw, a drive bell, and some grease.

This V-style cogged tooth pump belt is used in conjunction with the drive belt in your washing machine. This belt is all black in color and is made entirely of rubber. It is twenty-two and a half inches long and 3/8 of an inch wide

A dryer's idler pulley wheel serves to help the belt to rotate the drum.

Found at the end of the inlet hoses.

This knob accepts a D-shaped shaft.

Also known as the pump mounting screw.

This hose is almost 5 feet long and now comes with the washers for proper installation. It is used to bring water into your washer for the cycles.