AV447FBS General Electric Range Hood - Instructions

To replace a filter, on my range, i just pull down on the old ,and push up tp place the new one in. the were no screws ,to take out. I would like to say, that the time it took , to place my order and recive it was great. i could not be more pleased . i will be in touch, again, whenever, i need a part ! thank you.

First, unplug the range hood, then remove the switch cover plate, held by two Phillips screws. Remove the switch knob and the hex nut on the front of the hood.(In my case, the hex nut had snapped off with the threaded part of the switch in it.) Then gently pull the switch away from the hood and write down which color wire (black, yellow, ... Read more white) connects to which receptacle on the switch. The receptacles on the rear of the switch are marked L,1,2 and 3. 3 is left blank. Snip the wires from the switch, getting as close to the body of the switch as possible. Pulling them from the push-in receptacles doesn't work. Using a wire stripper, strip off about 1/2 inch of the wire insulation. Twist the exposed wires tightly and insert into the appropriate receptacles so that no bare wire shows. Insert the face of the switch into the hole on the hood so that the threaded portion protrudes. Using the hex nut provided, tighten snugly with an adjustable wrench. Do not over-tighten. Reattach the knob. Most of this repair went quickly and smoothly, but, despite repeated efforts, the threaded portion of the new switch did not fit through the original hole in the hood. As a result, I used a drill to enlarge the hole. The result was satisfactory but the new switch is not seated as well as the original. The knob does not line up exactly in the On, Off, Nite Light positions.

Popped out the old one and inserted the new one. Very quick and easy, less than 1 minute. I was very impressed with the delivery of my new filter from PartSelect. It arrived the very next day...that was simply amazing to me.

Easy snap on installation. Can't believe how quickly the part arrived - delivery time was only 24 hours!!!

Pulled filter, pulled little clip that holds fan on to motor shaft. Placed new fan on (make sure turned right way, hard not to) put clip in place put filter back on. Done.

Was so simple just take out the filter the clip and the fan and then put the new parts thank you

Had to coat braided wire with solder to make them stiff enough to push into switch.

It was a simple fix. Disconnect the power from the unit, Remove the switch guard/cover, Pry the wire loose with a small screwdriver. As you remove the wires connect them to the new switch, make sure you insert the wires in the same position as the old switch, everything is numbered or has a letter. After connecting the wires, screw the sw ... Read more itch into place, don't over tighten because the plastic is very fragile. Replace the guard/cover and you are done. Very simple, anyone can do it.

I stood on a kitchen step ladder, pulled old one out with an upward and outward pull. Held new one on the sides, seated the bottom first, then snapped the new one into the top clip.

I just needed a new filter for my stove overhead hood.

just replaced the filter on my range exhaust

Had to completly change out the switch. The job was really simple and couldn't have done it with out Parts Select. The parts are very reasonable and ship fast.

Removed old snap-on light cover and replaced it with the new one.

unscrewed old filter, replaced and installed new one

Easy. Took old filter out, put new one in.