AT15 - Parts

Sold Individually.

The speed nut (also referred to as a condenser motor fan nut), fits onto the condenser fan motor. The motor for this fan turns on simultaneously with the evaporator and the compressor motors, so a malfunction in the condenser fan motor could cause your fridge to cycle on and off more frequently or run too warm, or too noisily. Make sure t...Read morehat the speed nut is properly attached and tight. Check the nut for any signs of wear or damage. If the nut is damaged and refuses to tighten, you should replace the part immediately. Remember to unplug your refrigerator before starting this repair.

This support is used with the crisper drawer shelf.

This kit comes with the handle in white, screws and screw covers. Note: If your door has been reversed so the handle is on the right side, this handle becomes the freezer handle. Use freezer handle if your refrigerator hand is on the right side

This freezer shelf support stud is two inches long. It is all white in color and is made of plastic.

This upper hinge shim is just under two inches long. It is beige in color and is made of a thick paper. This shim is intended for use with refrigerator hinge assemblies.

This is an ejector arm, and it is used in conjunction with your refrigerator. The function of this part is to act as a cube ejector inside your ice maker. The arm will rotate inside the ice maker to allow the ice cubes to fall out of the marker and into the ice bucket. This part is made entirely of plastic, is white in color, and has eigh...Read moret teeth. It measures just over 9 inches long, and one and a half inches wide. To make this installation the tools you will need include a quarter-inch nut driver, a flat-head screwdriver, and a Phillips screwdriver.

This cut-to-fit refrigerator door shelf retainer bar comes at twenty-seven inches long. It is made entirely of metal.

Sold individually.