ASI25 Refrigerator - Parts

For white, biscuit, black and stainless models.

This part releases water from the supply line when it's activated.

This screw is sold individually.

Sold individually.

This is a crisper drawer shelf frame cover for models of refrigerator. This frame sits above the crisper drawer and allows a glass insert to be installed on top of it, for further food item storage and to properly seal the crisper drawer itself. If this frame is cracked, bent, or warped, it should be replaced immediately so it can properl...Read morey support the drawer that slides into it. This frame measures approximately 13 inches deep and 16 inches wide, and is made of durable white plastic. This frame is an OEM part, and does not include the glass insert that lays on top of it or the drawer that slides in below.

The light socket in your refrigerator houses the light bulb and connects it to the power source. If your refrigerator light is not coming on when you open the door, you may need to replace the light socket. Before you replace the light socket, be sure that your light bulb is in working condition, as this may solve the same problem. This l...Read moreight socket kit comes with 2 wire connectors, a light shield, and the new socket. The wire connectors that come with this kit are included so your new socket can replace a variety of old ones. If this light socket is different than your original, you will need to use the connectors to make it fit your refrigerator. Be sure to follow the instructions provided, so this part will fit your refrigerator properly.

This compressor start relay is for refrigerators. The compressor start relay attaches to the compressor and helps start the compressor motor. Safely store any food that could deteriorate while the power is off and unplug the refrigerator before installing this part.

Sold individually.

This ice auger support, also known as a baffle, is a manufacturer-approved replacement part for your refrigerator ice maker. This part can become cracked or damaged, preventing your ice auger from doing its job. This repair requires extensive disassembly; take photos as you go to make reassembly easier. To replace this part, life the ice ...Read moredoor out of the way and life the ice arm into the off position. Pull out the ice bucket and use a 1/4 inch nut driver to remove the screws holding the ice container and connecting rod in place. Pry the e-clip and washer off the bottom of the auger assembly. Use a 9/16ths wrench to remove the nut at the bottom of the auger. Pull off the auger teeth assembly and replace the auger support with your new part. Now you can begin reassembling.

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tra...Read morey can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

This wire freezer shelf fits in the freezer to provide storage space. It is made of white metal, measures approximately 14 inches wide by 12 inches deep, and fits into the side freezer glides for easy adjusting. While these shelves are strong, they can bend and break due to frequent and heavy use over time, and should be replaced if damaged.