ASD2522 Refrigerator - Parts

This ice auger support, also known as a baffle, is a manufacturer-approved replacement part for your refrigerator ice maker. This part can become cracked or damaged, preventing your ice auger from doing its job. This repair requires extensive disassembly; take photos as you go to make reassembly easier. To replace this part, life the ice ...Read moredoor out of the way and life the ice arm into the off position. Pull out the ice bucket and use a 1/4 inch nut driver to remove the screws holding the ice container and connecting rod in place. Pry the e-clip and washer off the bottom of the auger assembly. Use a 9/16ths wrench to remove the nut at the bottom of the auger. Pull off the auger teeth assembly and replace the auger support with your new part. Now you can begin reassembling.

Anti drip valve NOT included.

This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures.

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tra...Read morey can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

This part attaches to the drive shaft of the ice dispenser motor.

Sold Individually - Appliance originally takes 2.

This part is the top hinge for your refrigerator door. It is made of metal and is approximately 5 inches by 3 ¼ inches in size. This hinge is for the right side of the refrigerator door only. The left side hinge is sold separately. The top hinge allows your refrigerator door to open and close properly. If your door is hanging strangely, o...Read morer if the door won’t open or close properly, you may need to replace the top hinge. This part is sold individually and is an authentic OEM part.

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Sold individually.

This part may come with a plastic or metal auger depending on the factory. It will work with your appliance if found with the model number. (Make sure you install properly at back of ice container, because it must be engaged for the crushed ice feature to work).

This refrigerator door hinge kit is a genuine OEM replacement designed to support the lower hinges of both the freezer and refrigerator doors. Engineered for durability and precision, it ensures smooth door movement, proper alignment, and a secure seal—critical for maintaining temperature stability and energy efficiency. The kit includes ...Read moreboth left and right lower hinges and is compatible with a wide range of models across Whirlpool and affiliated brands. Common symptoms indicating the need for replacement include difficulty opening or closing doors, poor sealing, excessive noise from the hinge area, and misalignment. Installation may require basic tools and should be performed with the appliance powered off.

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read moreotective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.