ASD251 Admiral Refrigerator - Parts

This ice dispenser yoke is an inch and a half long. It is made of metal and is used with the ice enclosure of a refrigerator's icemaker assembly.

This limit switch, also known as a dispenser switch, is used in refrigerators and freezers. The function of this part is to control the dispensing of ice or water when the dispenser lever is pressed. The switch is over 1 inch long and comes in white or black. It is made from plastic and metal. If your refrigerator is having trouble dispen...Read moresing water or there is leakage, it is best to replace the switch. The tools needed for this repair are a #15 torks, #2 Phillips screwdriver, #1 Phillips screwdriver, and needle nose pliers. Remember to unplug your appliance from the power source before beginning this installation project and refer to the manual for further installation instructions.

This fill tube grommet is used to supply water to the icemaker and is partially located in the refrigerator/freezer wall.

This egg tray holds fourteen eggs.

This lower door hinge bracket is all white in color. It is almost three inches long and is made of metal.

This overload and relay is used for the compressor to help protect the motor from overheating.

Sold Individually.

The speed nut (also referred to as a condenser motor fan nut), fits onto the condenser fan motor. The motor for this fan turns on simultaneously with the evaporator and the compressor motors, so a malfunction in the condenser fan motor could cause your fridge to cycle on and off more frequently or run too warm, or too noisily. Make sure t...Read morehat the speed nut is properly attached and tight. Check the nut for any signs of wear or damage. If the nut is damaged and refuses to tighten, you should replace the part immediately. Remember to unplug your refrigerator before starting this repair.