ASD23 Amana Refrigerator - Parts

This is the replacement ice maker auger and crusher blade assembly for your refrigerator. It is approximately 15 inches long and 7 inches wide. The ice maker auger sits within the ice maker assembly and rotates to push the ice from ice container into the dispenser chute. If your ice maker bucket is full, but ice is not being dispensed, it...Read more is an indication that the auger is damaged. Be sure to disconnect power from the refrigerator before you repair the auger. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Sold individually.

This is an evaporator fan motor, it is 115 volts and 60 hertz and it is for your refrigerator/freezer. You will need to replace this part if your appliance is too warm or getting noisy. This evaporator fan motor is located in the back of the freezer. This part circulates air over the refrigerator coils. These coils will convert the heat i...Read morento cool air, which is then circulated throughout your appliance. To replace this part you will need a 1/4-inch nut driver and a pair of needle nose pliers.

Sold individually.

This part is the replacement ice chute door for your refrigerator/freezer. It is a round, black part that is approximately 2 ½ inches in diameter. The dispenser ice chute door opens to let ice through when dispensing into a glass or some other container. If the chute door is broken, your refrigerator may not be able to dispense ice proper...Read morely. Be sure to disconnect the power from your refrigerator before you begin this repair. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

This wheel is sold individually. It is located on the bottom of the refrigerator.

This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the coils.

This crushed ice wheel is five inches in diameter. It is beige in color and is made of plastic.

This part is the replacement shelf support for your refrigerator/freezer. It is made of white plastic and is approximately 1 inch by 1 inch. The shelf support attaches to the side of your refrigerator wall and supports the shelf. If your shelf is sagging or will not stay in place, you may need to replace the support. To replace the suppor...Read moret, use a wrench to turn the support clockwise until you can use a flat blade screwdriver to pop it out. Push the new support into the hole left by the old one until it is flush with the liner, then use the wrench to turn it clockwise until it locks in. This part is sold individually and is and OEM part.

Includes tubing.

This part is the replacement water filter cover for your refrigerator. It is made of white plastic and is approximately 13 inches long and 4 inches wide at the widest point. The water filter cover protects the water filter from damage while it is installed in the refrigerator. The main reason to replace the water filter cover is if it is ...Read morecracked, damaged, or missing. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Sold Individually. - * Part may differ in appearance, but functions same as original.