AS2728GIHB Maytag Refrigerator - Instructions

looked a website removed part found broken item order and installed in 15 minutes, easy simple fix very low cost change

rl

I couldn't have repaired the refridgerator at all if your web site didn't have photos along side of the parts. My parts no. was destroyed. But after removing the face plate on the ice dispenser door and checking the area behind the plate, the burned part was clearly identifiable. I removed the one screw holding it and the two connectin ... Read more g wires - and pulled out the tiny switch. On your site, I entered the refridgerator number, and the parts list (300 or so parts for this model) appeared with identifying photos of each part. All it took was to order the part (and the ice door simply because it was old) and put it in when it arrived in one day! No only did I save much cash, but I left with the confidence that I knew what went wrong. It works as good as new now. Thanks!!!!!

Removed drive assembly end of ice bin using socket wrench to get to old ice bin drive ring. Pull drive sssembly back to get ice bin ring out of the other end of ice bin. Installed new ice bin ring and and reinstall drive assembly end.

There was three screws to remove to unmout the ice maker, and unplug the wire harness,then two to remove to slip in new stripper. All took about 20 mins.

took off the covers and put in the new part and then put it back together.

Ordered the parts, snapped them into place on the basket and then slid the arms into the holes on the freezer door, very very simple..

The best part of the repair was how easy it was to find and order the part. Instead of searching the parts houses around town I just went to the PartSelect web site, quickly found and ordered the part in about five minutes, received the part the next day at my home and was ready to make the repair. Wow! What a pleasure for something to wo ... Read more rk the way it was meant to. Removed old switch located by prying out with sharp knife or screwdriver. Don't worry about breaking it or cracking plastic. Disconnect(unplug) wires from back of switch. Replace (plug-in) wires on back of new switch. Insert in location of old switch. Finisheed.

remove the screw on the front panel---

remove old part --- snap the new piece in

replace screw

just snapped the new one in. I am very happy. the part was delivered in just a few days--I was surprised how quickly it was delivered. thank you. I would use your company again.

installed new parts

I joined the front crisper and pan assembly by pushing the connecting parts together against the kitchen counter. They snapped into place.

I used my old parts to determine where the snaps were located and pushed hard enough to connect the parts together.

The grill was a simple push into the connecting area. It ... Read more was a no brainer.

replaced electric control board, defrost for six hours. next day (24 hours) same problem, [email protected]

Removed 5 screws, took unit apart, replaced part, put back together. Just be sure to have the solenoid connected to the ice door lever the right way before you reassemble.

I followed the instructions from other users and everything went fine. I had one issue not covered. My refrigerator doors are covered by cabinet panels, and the top panel had to be removed in order to remove the panel for the ice/water dispenser. The part was perfect and fairly easy to install!

I read what other people had done so I tried the easiest solution--Forced, without breaking, the plastic & fit the ring right where it needed to be.