AS22N8DM Admiral Refrigerator - Parts

This fill tube grommet is used to supply water to the icemaker and is partially located in the refrigerator/freezer wall.

This egg tray holds fourteen eggs.

Sold Individually.

The speed nut (also referred to as a condenser motor fan nut), fits onto the condenser fan motor. The motor for this fan turns on simultaneously with the evaporator and the compressor motors, so a malfunction in the condenser fan motor could cause your fridge to cycle on and off more frequently or run too warm, or too noisily. Make sure t...Read morehat the speed nut is properly attached and tight. Check the nut for any signs of wear or damage. If the nut is damaged and refuses to tighten, you should replace the part immediately. Remember to unplug your refrigerator before starting this repair.

This is an ejector arm, and it is used in conjunction with your refrigerator. The function of this part is to act as a cube ejector inside your ice maker. The arm will rotate inside the ice maker to allow the ice cubes to fall out of the marker and into the ice bucket. This part is made entirely of plastic, is white in color, and has eigh...Read moret teeth. It measures just over 9 inches long, and one and a half inches wide. To make this installation the tools you will need include a quarter-inch nut driver, a flat-head screwdriver, and a Phillips screwdriver.

Also known as Start Relay. This part briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.

This cold control thermostat cycles on and off regularly to keep your refrigerator cold.

This pin is used with the lower hinge assemblies of both the fresh food door and the freezer door of side by side refrigerators.