ART652 Amana Range - Instructions

After we got the part in the mail my husband put it on and shortened the wires and put new plugs on the ends of the wires and we had to get a new plug put it on and it was fixed.

My husband did the repair. It was so easy that I could have done it. He had to remove 3 screws and then hook up the element. Nothing to it!!

Insert one end of the railing into the slot in the back of the stove. Align the front end of the railing with the hole at the front of the stove. Align the roller with the hole. Secure the front end of the railing, roller ,and hole with the shoulder bolt using a 10mm wrench. Tighten just enough but don't over tighten.

F3 = Sensor failure. After reading other stories here it seemed like a quick DIY fix. It was fairly easy, except tham my Amana Model had very short leads to the sensor that made me have to pull the oven out to get at the back. It was still easy, however it did not fix the problem. Ultimately I hired a repair person and they found that the ... Read more underlying problem was a door hinge that had prevented the top of the door from sealing well and letting heat escape up near the control board. Over the years this had damaged the board, which is old and no longer made and the whole unit was totalled. Bummer for me but it was good that I tried and I will use PartSelect again (hopefully not soon, though).

Unscrew and remove old element, install new element.

Ordered hinge, went to Sears bought some tools to finish manufacturing the hinge, tapped out the screw hole, installed the hinge.

Pulled range away from wall and unplugged it. Pulled smoothtop out a bit to clear retaining clips. Swung top up and unplugged the cable going to top. Removed top hinge so top could be removed. Put top upside down on a table to work on. Removed wires from bad burner and then removed screws holding the burner in place. Replaced bad burner w ... Read more ith new one and reversed the previous steps. Range worked like new. PartSelect service was great, received the part in one day.

Discriptions provided by others in this section made it easy and there is little additional insight I can add. The part was delivered the next day. I don't reply to these requests for comments, as providing what I paid for is the expectation. But, this outfit did a good job.

turn the power off first, remove knobs, removed burners,disconnected wire from igniter,raise the top of the stove,re rmoved wire from the door lock removed two screws remove the door lock itself, then put all back on in same order as I remove. Main thing to remember is to writeyour colors of the wire down so you know where to replace the ... Read more m.

Had to screw off old terminal block & screw on new one