- Home
- ART318FFDW03
- Instructions
ART318FFDW03 Amana Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Refrigerator suddenly not staying cold. Freezer icing up about 1 month before.
2 of 2 people
found this instruction helpful.
-
PAUL from SANTA MARIA, CA
- Really Easy
- 30 - 60 mins
-
Nutdriver, Pliers, Screw drivers
Noticed the evaporator fan not spinning but would spin with a finger jump start. After looking up the part on the PartSelect liner parts diagram I found the installation video that really helped. After installing the fan it tested out fantastic. The fan was blowing air 10 times more than the old one. Refrigerator works great on the origin
... Read more
al econo setting.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Screws are a bit small and short for the job
2 of 3 people
found this instruction helpful.
-
Sheryll Lawrence from BRONX, NY
- Really Easy
- 30 - 60 mins
-
Screw drivers
Using a screwdriver
Other Parts Used:
Was this helpful?
Thank you for voting!
freezer (later fridge too) wouldn't stay cold~
2 of 3 people
found this instruction helpful.
-
David from MARYLAND HTS, MO
- Very Easy
- 30 - 60 mins
-
Nutdriver
****Make are you order Capacitor & Starter relay too (we ordered separtely so had to pay shipping twice)**** Super easy just open access panel on back near compressor and remove retention clip with fingers, remove & replace both capacitor & starter, put clip and acce
... Read more
ss panel back on, plug in and allow 8 hours to cool! Works like new again! Hope it goes another 10 years
Read less
Was this helpful?
Thank you for voting!
replaced cracked compartment door
2 of 3 people
found this instruction helpful.
-
john from NORWOOD, MA
- Really Easy
- Less than 15 mins
removed old and installed new compartment door by hand.
Was this helpful?
Thank you for voting!
Broke light switch while cleaning
2 of 3 people
found this instruction helpful.
-
Gail from Golden, CO
- Really Easy
- Less than 15 mins
use kitchen knife to pry out. replaced switch assemble and pressed back into place. Could not have done this with out help from previous customers. Thanks
Was this helpful?
Thank you for voting!
The Light Socket Burned Out.
5 of 13 people
found this instruction helpful.
-
MATTHEW from STOCKTON, CA
- Really Easy
- Less than 15 mins
I pulled the socket out and unplugged the wires. I replaced the light socket by plugging in the wires and snapping the light socket into place. A very simple fix.
Was this helpful?
Thank you for voting!
Light switch broke
2 of 4 people
found this instruction helpful.
-
Carolee from Spokane Valley, WA
- Really Easy
- Less than 15 mins
-
Screw drivers
Pried out old part with screwdriver. Unplugged. When new part came, just plugged it in and pushed the part into place.
Was this helpful?
Thank you for voting!
No cold
1 person
found this instruction helpful.
-
Jacqueline from LEXINGTON PK, MD
- Very Easy
- Less than 15 mins
-
Nutdriver, Pliers
Like you video
Was this helpful?
Thank you for voting!
Freezer occasionally had a temperature alarm.Clicking noise also.
1 person
found this instruction helpful.
-
Barry from FORD CITY, PA
- Really Easy
- Less than 15 mins
Was told capacitor was problem 90% of the time.Capacior was not the problem.Bad start relay.
Was this helpful?
Thank you for voting!
Fan was not spinning make it not cold in bottom part
1 person
found this instruction helpful.
-
Dylan from WHEELING, WV
- Very Easy
- Less than 15 mins
-
Screw drivers
Take screws out pull panel out unconnect the part connect new one and your done
Was this helpful?
Thank you for voting!
GASKET AROUND DOOR WAS LETTING AIR IN/ COLD AIR OUT
1 person
found this instruction helpful.
-
Susan from BONNEAU, SC
- Very Easy
- Less than 15 mins
Put gaskets in the car dash to get warm (90 outside), Pulled off old gasket and brought new one in and just inserted it into the slot around door. Was a little buckled but it straightened out after a few hours. Was very easy!
Was this helpful?
Thank you for voting!
Light rocker switch broke and refrigerator light couldn't go on.
2 of 4 people
found this instruction helpful.
-
Cathy from HOPATCONG, NJ
- Very Easy
- Less than 15 mins
I just popped out the old switch with a flat head screwdriver. Removed the connections and then installed new switch by reversing steps. Popped in back in and the light went on.
Was this helpful?
Thank you for voting!
Plugged it in.
1 person
found this instruction helpful.
-
Adam from GLOVERSVILLE, NY
- Really Easy
- Less than 15 mins
-
Nutdriver
Not so good that was not the problem. Fan is not seized and all the lights work and display is not on but lights up as well. No start once plugged back in after 15 minutes of being unplugged. Nothing same no change.
Was this helpful?
Thank you for voting!
freezer and refrigerator compartments not cold enough
1 person
found this instruction helpful.
-
Michael from Colorado Springs, CO
- Really Easy
- Less than 15 mins
-
Nutdriver
Used the suggested problem list here to narrow down that the repair was most likely the run capacitor. Poped the new one in and I now have better control of my compartment ranges. I have a temperature gauge in each compartment. Check them every opening of the doors.
Was this helpful?
Thank you for voting!
Bottom part of refrigerator wasn't getting cold
1 person
found this instruction helpful.
-
Chad from RIDGEFIELD, NJ
- Really Easy
- 30 - 60 mins
-
Pliers, Screw drivers, Socket set
$80 part motor fan replaced saved me $1000 or more on new fridge.
Called in and you guys helped out
You guys are the best.
Called in and you guys helped out
You guys are the best.
Was this helpful?
Thank you for voting!