Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Refrigerator suddenly not staying cold. Freezer icing up about 1 month before.
2 of 2 peoplefound this instruction helpful.
PAUL from SANTA MARIA, CA
Really Easy
30 - 60 mins
Nutdriver, Pliers, Screw drivers
Noticed the evaporator fan not spinning but would spin with a finger jump start. After looking up the part on the PartSelect liner parts diagram I found the installation video that really helped. After installing the fan it tested out fantastic. The fan was blowing air 10 times more than the old one. Refrigerator works great on the origin
... Read moreal econo setting.
****Make are you order Capacitor & Starter relay too (we ordered separtely so had to pay shipping twice)**** Super easy just open access panel on back near compressor and remove retention clip with fingers, remove & replace both capacitor & starter, put clip and acce
... Read moress panel back on, plug in and allow 8 hours to cool! Works like new again! Hope it goes another 10 years
Read less
Was this helpful?
Thank you for voting!
replaced cracked compartment door
2 of 3 peoplefound this instruction helpful.
john from NORWOOD, MA
Really Easy
Less than 15 mins
removed old and installed new compartment door by hand.
Was this helpful?
Thank you for voting!
Broke light switch while cleaning
2 of 3 peoplefound this instruction helpful.
Gail from Golden, CO
Really Easy
Less than 15 mins
use kitchen knife to pry out. replaced switch assemble and pressed back into place. Could not have done this with out help from previous customers. Thanks
Was this helpful?
Thank you for voting!
Freezer occasionally had a temperature alarm.Clicking noise also.
1 personfound this instruction helpful.
Barry from FORD CITY, PA
Really Easy
Less than 15 mins
Was told capacitor was problem 90% of the time.Capacior was not the problem.Bad start relay.
Was this helpful?
Thank you for voting!
Plugged it in.
1 personfound this instruction helpful.
Adam from GLOVERSVILLE, NY
Really Easy
Less than 15 mins
Nutdriver
Not so good that was not the problem. Fan is not seized and all the lights work and display is not on but lights up as well. No start once plugged back in after 15 minutes of being unplugged. Nothing same no change.
Was this helpful?
Thank you for voting!
No cold
1 personfound this instruction helpful.
Jacqueline from LEXINGTON PK, MD
Very Easy
Less than 15 mins
Nutdriver, Pliers
Like you video
Was this helpful?
Thank you for voting!
Warm fridge and freezer but compressor was running. No air distribution inside fridge
1 personfound this instruction helpful.
Brian from BURTON, MI
Really Easy
15 - 30 mins
Nutdriver
I turned breaker off to fridge, it was easier than pulling fridge out in camper. I took 4 screws out of back panel that revealed the evap fan, took 2 more screws out to take fan bracket off. Unplugged fan plug. Took fan blade off the non working evap motor and put it on the new evap motor. Put all the screws back in the reverse orde
... Read morer and flipped the breaker and air started circulating.
Read less
Was this helpful?
Thank you for voting!
door hinge broke.
2 of 4 peoplefound this instruction helpful.
Bernard from DONALDSONVLLE, LA
Really Easy
15 - 30 mins
Nutdriver, Screw drivers
Removed door and replaced bushing bracket was ok.
Was this helpful?
Thank you for voting!
freezer and refrigerator compartments not cold enough
1 personfound this instruction helpful.
Michael from Colorado Springs, CO
Really Easy
Less than 15 mins
Nutdriver
Used the suggested problem list here to narrow down that the repair was most likely the run capacitor. Poped the new one in and I now have better control of my compartment ranges. I have a temperature gauge in each compartment. Check them every opening of the doors.
Was this helpful?
Thank you for voting!
The Light Socket Burned Out.
5 of 13 peoplefound this instruction helpful.
MATTHEW from STOCKTON, CA
Really Easy
Less than 15 mins
I pulled the socket out and unplugged the wires. I replaced the light socket by plugging in the wires and snapping the light socket into place. A very simple fix.
Was this helpful?
Thank you for voting!
Light switch broke
2 of 4 peoplefound this instruction helpful.
Carolee from Spokane Valley, WA
Really Easy
Less than 15 mins
Screw drivers
Pried out old part with screwdriver. Unplugged. When new part came, just plugged it in and pushed the part into place.
Was this helpful?
Thank you for voting!
Cheap plastic part prone to break if crisper drawer jams even slightly.
1 personfound this instruction helpful.
Edward from SILVER SPRING, MD
Really Easy
30 - 60 mins
Nutdriver
After left side track broke 3 times and then center track also broke, I got tired of buying replacements (even though they are easy to install and not very expensive). So I bought a tube of plastic epoxy and a bit of fiberglass cloth and reinforced the plastic that the (#8 x 1/2 inch) screws go through (where it breaks) on ALL 3 tracks,
... Read morethen redrilled holes, added a washer, and used #8 x 5/8 inch screws). Maybe these wiil last.
Read less
Was this helpful?
Thank you for voting!
freezer became frosty but refrigerator's camera didn'thave any coll at all.
1 personfound this instruction helpful.
Yakov from BROOKLYN, NY
Really Easy
30 - 60 mins
Screw drivers, Socket set
After describing my problem PartSelect consultant emmidiately diagnost the problem and I ordered Evaporator Fan Motor. Along with purches order confirmation I got video how to install a new motor. The hardest part was to connectthe ground wire becase space in that area was verylimited. Otherwise it was just like a walk in the park.
... Read morer />As soon as I installed motor and turned on the refrigirator, everything start working properly. Thank you PartSelect, you sved me hundreds of dollars.
My Orders
