AP13 - Parts

This replacement belt is a genuine OEM sourced item that is designed for a Ridgid planer. It is the main drive belt for the unit that will rotate the cutter. Over time belts tend to wear out and stretch eventually requiring replacement. Keep an eye on the belts condition and replace it as needed to maintain optimum performance. This item is made from durable rubber and it is sold individually.

This is a genuine part assembled by the original manufacturer. It is used in some Ridgid handheld power tools such as planers. These bearings hold the infeed (front) and outfeed (rear) rollers so that they can spin freely. Bearings are used to buffer moving parts so that they aren't damaged from friction, allowing for smooth motion. They ...Read morealso allow for controlled and steady directional movement. Bearings are high-wear parts and should be replaced relatively often. This bearing is sold individually. Please note that springs, screws, and retainers etc. are sold separately.

This is an authentic Ridgid replacement part manufactured for use with thickness planers. The special overload protector is used to prevent the motor from overheating and potentially damaging the equipment. This overload protector is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine OEM sourced replacement part designed for use with Ridgid planer. This assembly includes one (1) carbon brush with a lead wire and a spring attached. Carbon brushes are a commonly replaced part on power tools. Due to normal use and friction brushes will gradually wear down and will require replacement. It is advised to ...Read morereplace both brushes at the same type. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • First remove the brush caps • Take our old brushes and replace them with the new ones • Secure brush caps and test the tool