EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

AMV6502RES2 Whirlpool Microwave Oven Combo - Instructions

All Instructions for the AMV6502RES2
76 - 90 of 113

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
The support became distorted and needed to be replaced.
0 of 1 people found this instruction helpful.
  • Mary from Wilmington, OH
  • Really Easy
  • Less than 15 mins
I simply lifted out the glass rotating plate and inserted the new support. How complicated can that be?!!!!!!!!!!!!!!!!!!!!!!!!!!!
Was this helpful?
Thank you for voting!
Charcoal Filter Replacement
0 of 1 people found this instruction helpful.
  • Charles from Meridian, MS
  • Really Easy
  • Less than 15 mins
  • Screw drivers
This is an under the counter microwave. Simply removed the two screws holidng the vent grille on top of the unit, lift out the old charcoal filter, clean the vent fan exit surfaces then replace the filter and put the vent grille back. Be careful to not drop either of the two screws after one is installed as you will have to take the gri ll off and start the screw installation again unless you have a magnetic to retrieve the dropped screw. An easy five minutes at most to change.
Was this helpful?
Thank you for voting!
Microwave had no electrical
1 of 5 people found this instruction helpful.
  • Larry from HARKER HTS, TX
  • Really Easy
  • 30 - 60 mins
  • Pliers
I was sent the wrong fuse by you. I had to procure a fuse in another manner. Very disappointing. The repair was simple. It just took longer because of the failure to send the correct fuse.
Was this helpful?
Thank you for voting!
Burnt Out Light Bulb Replacement
9 of 30 people found this instruction helpful.
  • alfred from summerville, SC
  • Easy
  • Less than 15 mins
  • Screw drivers
Open compartment, installed bulb, closed compartment
Was this helpful?
Thank you for voting!
it was working fine and it stopped order a fuse and it wasn't the problem
0 of 4 people found this instruction helpful.
  • Herb from Auburn, IN
  • A Bit Difficult
  • 1- 2 hours
took it to Buttermore appliance in Auburn Indiana and he changed the fan and added another fuse
Was this helpful?
Thank you for voting!
Put the Fuse in, then plugged it in came on for a min then everything went out!!!!!
4 of 18 people found this instruction helpful.
  • Stephen from SPRINGFIELD, WV
  • Very Difficult
  • 1- 2 hours
  • Pliers, Screw drivers
Took the front off and behind a plate was the fuse, so I replaced it for what good that did!!!
Was this helpful?
Thank you for voting!
Filter dirty
  • John from Denver, CO
  • Easy
  • Less than 15 mins
  • Screw drivers
I unscrewed the filter cover, replaced the charcoal filter and replace the cover. The other wire mesh filter slides right into place. You sent me the right parts for my filter replacement on my microwave. Easy install. Thanks
Was this helpful?
Thank you for voting!
burnt out light bulb
  • Shirley from Londonderry, NH
  • A Bit Difficult
  • Less than 15 mins
  • Screw drivers
The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.
Was this helpful?
Thank you for voting!
Burned out light bulb
  • Ray from Gatlinburg, TN
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Replaced light bulb.
Was this helpful?
Thank you for voting!
replace light blub
  • roger from palm coast, FL
  • Really Easy
  • Less than 15 mins
removed grill cover, removed bulb plate, unscrew bulb, screw new bulb in socket,put bulb cover back on and screw grill cover back on. no issues whatsoever.
Was this helpful?
Thank you for voting!
Replace filters
  • David F from BONITA SPRINGS, FL
  • Really Easy
  • Less than 15 mins
  • Screw drivers
For grease filter, just slipped it in outside area. For charcoal filter, unscrewed the top of microwave and replaced existing filter, then screwed back the top.
Was this helpful?
Thank you for voting!
Needed a clean filter
  • Ethel from New Berlin, WI
  • Easy
  • Less than 15 mins
  • Screw drivers
Stood on a step stool (microwave over stove), took off the one panel,removed old filter and put in new one
Was this helpful?
Thank you for voting!
The capacitor was melted in the microwave
  • Jocelyne from Fort Pierce, FL
  • Really Easy
  • Less than 15 mins
  • Screw drivers
My husband open the microwave and see the capacitor melted. He try to find the piece in store,but unfortunatly he didn't find any. I found the piece on the web and ordered it. My husband replaced the part easily. The microwave work very well.The microwave was to our friend. He did replace it by a new one. Now we have a new microwave with a fan.
Was this helpful?
Thank you for voting!
Reminder signal and message to change filter on microwave digital display.
  • Susan from North Olmsted, OH
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Removed 2 screws on the top of the microwave and removed top/front piece of microwave. Slid out old filter (which didn't look dirty at all) and replaced it with the new one. Replaced top/front piece and 2 screws. It took less than 5 minutes.
Was this helpful?
Thank you for voting!
Burn't out bulb.
  • Carter from McCordsville, IN
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Removed the glass cover and replaced the bulb. Very simple.
Was this helpful?
Thank you for voting!
All Instructions for the AMV6502RES2
76 - 90 of 113