- Home
- AFB2234WES5
- Instructions
AFB2234WES5 Amana Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Fridge and freezer were too warm
2 of 2 people
found this instruction helpful.
-
Illyssa from GREELEY, CO
- Really Easy
- Less than 15 mins
-
Pliers, Screw drivers
Chose these parts based on suggestion on this website, as well as other sites. They did not correct the problem. Shipping was also quite slow.
Other Parts Used:
Was this helpful?
Thank you for voting!
broken drawer glides
2 of 2 people
found this instruction helpful.
-
John from JONESBOROUGH, TN
- Very Easy
- Less than 15 mins
-
Screw drivers
removed the shelf, unscrewed 2 screws in each side. Removed broken glides and installed new ones in the reverse order..
Other Parts Used:
Was this helpful?
Thank you for voting!
Gasket not sealing good
2 of 2 people
found this instruction helpful.
-
Vince from Miami, FL
- Very Easy
- Less than 15 mins
Opened the bottom freezer door and pulled the gasket out of the groove. Pulled it out around the door and put the new one back around the door and the pressed into the groove. There was one place that a flat spot didn't take shape so I used a blow dryer to heat it up some and now it seals perfectly.
Was this helpful?
Thank you for voting!
When the support frame broke we threw the entire system into the trash DUH !
2 of 2 people
found this instruction helpful.
-
Bruce from CLARKSVILLE, VA
- Really Easy
- Less than 15 mins
Thanks for the video showing how to replace the Humidity Slide the knowledge that the end with the flair needed to be slightly bent to SNAP into place was a big help.
Other Parts Used:
Was this helpful?
Thank you for voting!
Right Door Magnet weak, door would not stay firmly closed
2 of 2 people
found this instruction helpful.
-
Larry from CHIRENO, TX
- Really Easy
- Less than 15 mins
Replaced seal on door. Same problem. Went to Lowe's and got several magnetic cabinet door catches. Attached them to the top of the door. (they can be seen sticking up), with the magnet part screwed to the door and the metal plate attached to a small wooden block glued to the top of the body with contact cement. Cost abound $16.
... Read more >
"To infinity and beyond."
... Read more >
"To infinity and beyond."
Read less
Was this helpful?
Thank you for voting!
After 19 years of use, both side glides of deli tray had cracked.
2 of 2 people
found this instruction helpful.
-
Liz from ELMHURST, IL
- Very Easy
- Less than 15 mins
Just 2 screws on each side - took them out, installed new glides with existing screws.
Very easy - ended up giving the fridge a thorough cleaning - fridge cleans so easy and quickly.
Very easy - ended up giving the fridge a thorough cleaning - fridge cleans so easy and quickly.
Other Parts Used:
Was this helpful?
Thank you for voting!
The drawer glides were broke.
2 of 2 people
found this instruction helpful.
-
Greg from WAKEMAN, OH
- Very Easy
- Less than 15 mins
-
Screw drivers
Couldn't have been easier. Took around 5 minutes. All you have to do is remove 4 Phillips head screws, put on new drawer glides, put the screws back in and your done.
Other Parts Used:
Was this helpful?
Thank you for voting!
Deli drawer support had broken
2 of 2 people
found this instruction helpful.
-
Glenn from NEW ALBANY, IN
- Very Easy
- Less than 15 mins
-
Screw drivers
Ordered a replacement Deli Drawer Guide for the right side. Very simple repair, the plastic deli drawer guide is attached to the metal shelf support with two phillips screws. the repair was completed in less than 10 minutes.
Was this helpful?
Thank you for voting!
Ladder hooks broke
2 of 2 people
found this instruction helpful.
-
Miguel from ESCONDIDO, CA
- Very Easy
- Less than 15 mins
Pulled out broken parts and snapped/ pushed into place new ladder hooks 15 min max
Was this helpful?
Thank you for voting!
The center rail was broken
2 of 2 people
found this instruction helpful.
-
Joella from THE DALLES, OR
- Very Easy
- Less than 15 mins
The part just snapped in. super easy.
Was this helpful?
Thank you for voting!
Had to replace the pivot block and vertical rail
2 of 2 people
found this instruction helpful.
-
Myles from BETHLEHEM, PA
- Very Easy
- Less than 15 mins
-
Screw drivers, Socket set
Couldn't be easier. Swapped out the old parts with the new. 3 screws total. Perfect fit. Like we have a new fridge now.
Other Parts Used:
Was this helpful?
Thank you for voting!
Vertical mullion rail broken
2 of 2 people
found this instruction helpful.
-
David from Massena, NY
- Very Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
backout one screw, push mullion up and free from upper and lower slotted tabs, disconnect one electrical connector. Reverse the steps to reinstall. Literally took 2 minutes.
Other Parts Used:
Was this helpful?
Thank you for voting!
The vertical mullion rail went bad
2 of 2 people
found this instruction helpful.
-
Ed from OCEAN CITY, NJ
- Very Easy
- Less than 15 mins
-
Nutdriver
I left this broken rail hang off my refrigerator for almost a year I finally decided to investigate the possibility of ordering the part on line. I found the part on line in minutes and when I received the part it literally took me 3 minutes to install.
Was this helpful?
Thank you for voting!
Cracked humid drawer
2 of 2 people
found this instruction helpful.
-
Julie from BATH, PA
- Very Easy
- Less than 15 mins
Complete replacement of the plastic drawer.
Was this helpful?
Thank you for voting!
Broken Draw Guide
2 of 2 people
found this instruction helpful.
-
Clayton from DUVALL, WA
- Very Easy
- Less than 15 mins
-
Screw drivers
Simple! Remove and replace two screws.
Other Parts Used:
Was this helpful?
Thank you for voting!