ADW8 Amana Dishwasher - Parts

This wheel attaches to the inside of the tub to help guide the track and support the top rack.

Sold individually.

The short dispenser door retaining pin latches your washing machine door to the hinge. If you find that your washing machine will not dispense detergent, or the lid will not latch properly, you may need to replace the short dispenser door retaining pin. This pin is less than one inch in diameter, and is the shorter of the two hinge pins. ...Read moreTo find the larger hinge pin, search WP6-912678. This part is cylindrical and is made of metal. The short dispenser door retaining pin is sold individually. This is an OEM part sourced directly from the manufacturer.

Sold individually. This part is exactly 1 inch long.

This grommet for your soap dispenser door is just under an inch long.

This black water deflector is sold individually. It is used to keep water away from the dishwasher door.

This is a dishwasher wax motor actuator that opens the dispenser cover to dispense dishwashing detergent and rinse aid during the wash cycle in your dishwasher. This is an authentic OEM part from the genuine manufacturer. It is a little over 2 inches long, and mostly red in colour. Disconnect power from your appliance because electrical w...Read moreires will be exposed during repair. The wax motor is held in place by two tabs for easy release. Once you have gained access to the actuator, simply separate the two tabs and replace the part. This part is sold separately.

This pump housing filter is twenty-three inches long and a little over two inches wide. This filter wraps around a dishwasher's pump housing and clips in place. It is all white in color and is made of plastic with a mesh screen.

This lower dishwasher spray arm is just about twenty inches in length and three inches wide in the center. Also, this spray arm is gray in color.

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

This impeller rotates and is used to force water up through to the spray arm.

This upper discharge housing gasket is fifteen inches long.