ADW6 Amana Dishwasher - Parts

Sold individually. This part is exactly 1 inch long.

This grommet for your soap dispenser door is just under an inch long.

This black water deflector is sold individually. It is used to keep water away from the dishwasher door.

This is a dishwasher wax motor actuator that opens the dispenser cover to dispense dishwashing detergent and rinse aid during the wash cycle in your dishwasher. This is an authentic OEM part from the genuine manufacturer. It is a little over 2 inches long, and mostly red in colour. Disconnect power from your appliance because electrical w...Read moreires will be exposed during repair. The wax motor is held in place by two tabs for easy release. Once you have gained access to the actuator, simply separate the two tabs and replace the part. This part is sold separately.

This pump housing filter is twenty-three inches long and a little over two inches wide. This filter wraps around a dishwasher's pump housing and clips in place. It is all white in color and is made of plastic with a mesh screen.

This lower dishwasher spray arm is just about twenty inches in length and three inches wide in the center. Also, this spray arm is gray in color.

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be care...Read moreful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

This impeller rotates and is used to force water up through to the spray arm.

This upper discharge housing gasket is fifteen inches long.

Water that fills your dishwasher lifts this float. When it reaches a certain level, the float triggers the float switch to shut off, thereby shutting off the flow of water into the dishwasher.

This part holds the rinse aid liquid in the dispenser until the timer activates the rinse cycle.