ADB2500AWS1 Amana Dishwasher - Parts

This replacement part is a door latch assembly for a dishwasher. The latch keeps the appliance door closed while it is running, and prohibits the dishwasher from starting when the door is open. Depending on your model, you will need to remove approximately eleven screws to remove the inner panel and access the latch assembly. The latch as...Read moresembly is connected by two wiring harnesses that are nearly identical, so it is recommended to make note of where each harness goes before continuing with the repair. You will need a Torx screwdriver to complete the repair. Disconnect the dishwasher from the power source before beginning this repair.

This hose clamp is used in a wide variety of household appliances. Most often it is found in washers, dishwashers, refrigerators, freezers, dehumidifiers, garbage disposals, or air conditioners. This clamp is used to securely attach a hose to another part of your appliance, which helps prevent leaks from those connections. Depending on th...Read moree appliance, it can attach hoses to drain pumps, water inlet valves, pressure switches, and injector nozzles. We recommend you refer to model-specific diagrams for appropriate uses and exact placement. This hose clamp is made of metal, and is sold individually. To access and replace this part you will need a nut driver, pliers, and screwdrivers. Before you begin any repair work, make sure you have unplugged your appliance, and shut off the water supply if applicable.

This genuine inner door foam insulation strip, sometimes known as bottom seal foam, is used to create a waterproof seal that helps prevent leaking from the door area of the dishwasher. The existing insulation strip may leave a sticky residue or leftover disintegrated strip that must be scraped off before installing the new strip. Residue ...Read morecan be scraped off with a putty knife. Be sure to remove all residue and clean surrounding areas of the dishwasher build. It is strongly recommended to check other sealant parts on the dishwasher door such as the door gasket and dispenser grommet to ensure the leaking issue is fully solved.

This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

The docking station is located on the water supply tube at the far back. It provides water to the upper and middle spray arm and also includes the flappers.

This is a part for your dishwasher. The door cable link helps to keep the door steady and give support to the weight of the door when it is being opened or closed. If you notice the door latch has failed or the door is not closing properly, this might indicate a need to have the door cable link replaced. To perform this repair, you will s...Read moretart by turning the power off from the appliance. You will need to pull the unit out of installation. To access the cables, you will need to remove the side panel. You should be able to see the cables underneath the panel once removed.

This is the replacement water valve for your dishwasher. The water inlet valve connects to the water source and solenoid wires, and ensures the tub has the right amount of water entering it. If your dishwasher continues to fill after it is full, or if it fills slowly, you may need to replace this valve. Before you begin this repair, be su...Read morere to disconnect the water and power sources from your dishwasher. This part is sold individually and is an OEM part sourced directly from the manufacturer.

It provides a waterproof seal between the tub and the door.

This kit includes the dishrack, clips, wheels and silverware basket. As per the manufacturer this kit no longer includes the tines.

This spray arm is located on the lower half of your dishwasher. Water is forced through this spray arm by the unit's pump and motor assembly. The force of the water propels the spray arms, spraying water and detergent onto the dishes on the dishrack.

Water that fills your dishwasher lifts this float, and when it reaches a certain level, it acts as a trigger for the float switch. The float triggers the switch to shut off, thereby shutting off the flow of water into the dishwasher.