EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

ADB1500AD Dishwasher - Instructions

All Instructions for the ADB1500AD
16 - 30 of 284

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
clean light flashing 7 times would not run
18 of 23 people found this instruction helpful.
  • Mark from Winchester, VA
  • Really Easy
  • 30 - 60 mins
  • Screw drivers, Wrench (Adjustable), Wrench set
removed screws holding dishwasher to counter top,raised leveling pads,pulled dishwasher out, unplugged wiring,removed hold down nuts from inside dishwasher and installed new heater element, this was all easy the hard part was finding the code to reset the dishwasher there was no paperwork inside the dishwasher although there was an empty plastic holder.The code that worked for my model was with the door open to push the normal wash button then the high temp button three times as fast as you can within four seconds then close the door. It worked and reset the dishwasher which ran a short cycle then shut down as normal and is now working fine.After doing this select the beverage of your choice and relax. Hope this helps someone.
Was this helpful?
Thank you for voting!
Lower spray arm worn out
15 of 17 people found this instruction helpful.
  • Shawn from WEIRTON, WV
  • Really Easy
  • Less than 15 mins
Took less than one minute
Was this helpful?
Thank you for voting!
Friction sleeve
14 of 15 people found this instruction helpful.
  • Dave from PALM BAY, FL
  • Really Easy
  • 15 - 30 mins
  • Screw drivers
Make sure you order 2. One on each side
Was this helpful?
Thank you for voting!
Water not draining from the dishwasher
13 of 13 people found this instruction helpful.
  • Frederick from BIG PRAIRIE, OH
  • Very Easy
  • 30 - 60 mins
  • Screw drivers, Wrench (Adjustable)
I watched the video and this was the easiest repair ever. Took longer to disconnect and reinstall than it did to change out the pump. Highly recommended watching the video
Was this helpful?
Thank you for voting!
No heat. Replaced thermostat
13 of 14 people found this instruction helpful.
  • Tim from BURTONSVILLE, MD
  • Really Easy
  • 30 - 60 mins
  • Screw drivers, Socket set
Was able to replace and repair without taking the dishwasher out. Thermostat is behind and to the left of the power junction box. Has 2 wires going to it. It is up against the bottom of tub. I used an angled mirror to see what I was doing. 1 small screw to detach and pull down thermostat. Be sure power is off before you start. Also reprogrammed defaults. Hit any button 1-2-3, 1-2-3, 1-2-3, fast and close door. Let it sit 15 min to run and re-set defaults. Now I have heat and dry dishes.
Was this helpful?
Thank you for voting!
Broken wheels on upper dw rack
14 of 17 people found this instruction helpful.
  • Susan from Hanson, MA
  • Easy
  • 15 - 30 mins
  • Screw drivers
My 2 parts were delivered very quickly. We had been putting off the repair, mainly because any time you hire a capable repair man, the charge to "walk through the door"is very high. I actually thought about buying a new DW for this reason . . . Then I googleD PARTS, And was lucky to find PARTS SELECT. I was most impressed with the grap h layout of the parts, which enables the buyer to actually measure the part being replaced to be sure the correct item is being ordered. The instructions were excellent, and this grandmother took care of the repair, easily.
Was this helpful?
Thank you for voting!
Dish washer would not drain properly
14 of 17 people found this instruction helpful.
  • Kelli from BURLINGTON, MA
  • Very Easy
  • 15 - 30 mins
Shut off breaker. Took off front skirt of dishwasher .
Used pliers to loosen the pressure clamp on drain pump , have towel handy as there will be some water. Turn pump to left as you push in on the clip on side of drain pump. It will come out. Remove wire plug from old pump and plug into new pump than insert new pump and turn an d push in till it clicks. Use pliers to pinch hose clamp and push hose onto pump release hose clamp. Turn breaker on. Run a cycle and make sure all is tight before putting skirt on front.
Was this helpful?
Thank you for voting!
The dishtrack wheel came off the track and fell into the dishwasher and melted
14 of 17 people found this instruction helpful.
  • Timothy from huntersville, NC
  • Really Easy
  • Less than 15 mins
I snapped on the new part onto the track. It was that easy! :) Thank goodness the part was available from Part Select!
T. Edwards
Was this helpful?
Thank you for voting!
The dishwasher quit circulating the water and cleaning the dishes it filled heated drained
12 of 12 people found this instruction helpful.
  • Carol from HARRAH, OK
  • Really Easy
  • Less than 15 mins
The cost part plus shipping for each piece which was described as not cleaning properly due to not spraying. Each of these prices is part plus shipping, diverter valve $28.32 diverter motor did not fix the problem diverter motor $125.08 did not fix the problem my next option is the motor assembly which comes out to $311.53. I think they l ead you on with the little parts and you work your way up with the big ones expense wise at this point I will simply cut my losses and buy a new dishwasher because I'm almost at what it would cost for a new one and I've had this one for 4 years. When I went to look for what the problem was each one of these said not cleaning properly which I think now is a generic term to just go from the smallest to the largest if I'm going to replace the motor for 300 plus dollars I might as well just buy a new washer
Was this helpful?
Thank you for voting!
Drain Pump was giving off a burning smell. When I pulled the dishwasher out it had some light smoke coming from the Drain Pump
13 of 15 people found this instruction helpful.
  • Armand from N STONINGTON, CT
  • Really Easy
  • 15 - 30 mins
  • Screw drivers
Shut the power to the dishwasher off. Pulled unit out from under the counter top and raised the left hand side up for easy access. Disconnected the wiring, undid the clips, turned counter clockwise and removed. Reversed the order for installation and Connected the power. Ran several cycles successfully. Problem fixed. Burnt out water pump . Good as new if not better so far. Easy item search, Fast Shipping, Quality Part, Fair Pricing. Thank You Partselect.com
Was this helpful?
Thank you for voting!
Scratches in Surface
83 of 227 people found this instruction helpful.
  • Michelle from Richardson, TX
  • Really Easy
  • Less than 15 mins
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.
Was this helpful?
Thank you for voting!
friction sleeve broke
11 of 12 people found this instruction helpful.
  • Roxy r from GERMANTOWN, TN
  • Really Easy
  • 30 - 60 mins
  • Screw drivers
Unscrewed the top of the dishwasher from the counter top and slid the appliance out part way in order to reach the door spring. I loosened he spring from the bracket then slid the sleeve over the bracket. I reattached the spring to the bracket, slid the dishwasher back in and screwed it to the top just like it was prior to removal. Easy as pie.
Was this helpful?
Thank you for voting!
Heating element was not working
12 of 16 people found this instruction helpful.
  • Joseph from Mountain Top, PA
  • Really Easy
  • 30 - 60 mins
  • Screw drivers, Wrench (Adjustable)
Very easy repair !!! I ordered my heating element on a Friday , it was on my porch Saturday. I used the directions that Parts.com sent me . I also read everyones Installation instructions ..... Every step was very easy . I did watch a utube video , so I couldn't screw this repair up......... My wife had a new dishwasher picked out for $ 579.00 , my part was $29 dollars , savings $550 dollar ...... After the repair , I ran the dishwasher and the blinking clean lite took care of itself ... The water has never been this hot and dryers the dishes like it was a new dishwasher ...... My advice , read everyone's Installation instuctions and watch the utube video .....
Was this helpful?
Thank you for voting!
Water didn’t drain
12 of 16 people found this instruction helpful.
  • Ilir from WETHERSFIELD, CT
  • Really Easy
  • 30 - 60 mins
  • Nutdriver, Screw drivers
The repair was really easy. First disconnected electricity staring with fuses and removing wires from dishwasher, then disconnected drain hose and water hose. Pulled it out and removed pump turning clockwise no need for tools and same way installed new one. Very easy
Was this helpful?
Thank you for voting!
Water coming out both sides of the bottom of the door.
11 of 13 people found this instruction helpful.
  • Michael from HAMILTON, NJ
  • Really Easy
  • Less than 15 mins
Replaced Arm spray...
Turn it left and it comes off......place new spray in .. turn it right...and it's in...make sure it moves freely.......Arm wasn't turning and water was consistently hitting the front door.....I also replaced the door seal...
Was this helpful?
Thank you for voting!
All Instructions for the ADB1500AD
16 - 30 of 284