AD35DSS1 Whirlpool Dehumidifier - Parts

11-16 x 3/4 Sold individually.

The humidistat control, used in dehumidifiers, switches the dehumidifier on and off automatically to maintain humidity. If the switch does not work, the humidifier will not maintain the temperature properly. For this repair, screwdrivers are the only tools needed. First remove the knob and the screws from the top. Pry back the plastic ret...Read moreainers on one side of the old humidistat and remove wires before installing the new part and reattaching the two wires that connect to it. Remember to unplug the humidifier from the power source before installation.

This part is for your dehumidifier. The bucket water level switch is used to prevent water overflow when the bucket is full. You will not be able to tell if the switch has failed just by looking at it. You will need to perform a continuity test. This will determine if a continual electrical path is present. If you notice that dehumidifier...Read more will not run even when the bucket is empty, it might be due to the switch needing to be replaced. To access the part, you will need to remove all the outer housing. The switch is located in a plastic holder found on the inside wall.

A zip tie, also known as a cable tie or a wire tie, is a fastening device that holds wires or tubing together. If a machine has wires or tubing that are easily shifted, you need to hold them tightly together using a zip tie. It is a flexible, plastic strip that has serrated teeth and a locking mechanism. If the zip tie is damaged, it shou...Read moreld be replaced. Freely moving wires may rub against surfaces, causing them to break over time. Zip ties are single-use and may not be reused after they are removed from a machine. To release the locking mechanism, you will need to insert a small flat tool into the head of the zip tie, between the tongue and the serration, and depress the bar. You can then pull the teeth out of the mechanism to loosen the cable tie. This part is produced by the original equipment manufacturer and is sold individually.

This access valve is an authentic manufacturer parts kit used in appliances with a refrigerant such as the refrigerator and air conditioner. This kit includes a valve body, valve core and a valve cap. The body and cap are made of brass while the core is made from steel. If you notice that your appliance is leaking, not cooling adequately ...Read moreand the valve components are corroded, you should replace the access valve. As part of your general maintenance, you should also replace the valve if your appliance is more than 10 years old and the valve has never been changed. Use a valve wrench to remove the valve cap and use a core removal tool to pull out the core. Install the new valve body, core and cap and ensure they are securely fitted. Note that these parts are sold together.