ACV1 Whirlpool Air Conditioner - Instructions

ordered new part, removed old unit, noted where wires connect, installed new one, done.

Took out old filter and replaced it with the new filter

Replaced the temp control and sensor. Controls on this unit are easy to get to and electrical connections were slide ons

I received the part the very next day which was awesome, but when I went to install it, there was a connection discrepency on the back of the switch, and the screw holes were completely off in the front where it connects to the unit. I ended up taking the whole thing apart to try to put the old face with the right screw holes on the new p ... Read more art and ruined it.

Received the thermost from you in 2 days. (fast and reasonable shipping)

Removed 2 control knobs and front cover.

Removed 2 screws holding controls mounting plate. (About 3 X 6 inches in size)

Removed 2 screws holding thermostat in place.
Installed new trhermostat.

Checked the RAC and all ... Read more was OK.

As a matter of fact, I had to wait for the wife to finish cleaning the front of the RAC.

I am 75years young, retired, repaired appliances for a a short period when I was young before becoming a Factory sales rep. for RCA corp.

I appreciate your fast service and accurately sending me the actual part that I ordered.

Thanks again,
Frank

Just removed the old filter and replaced. Slid right in, no tools required.

Removed back cover, and installed the water valve. Removed the water supply tube cover and installed the supply tube. Opened freezer and removed the electrical cover, removed the knockouts and pulled line out. Hooked up ice maker and installed it to wall. Turned water on and waited a couple hours, it is making ice. Installing the ice ... Read more maker was easy. Running water line to it........well that is another story. LOL.

even I can replace a control knob....

Unplugged unit.
Pulled front cover and removed switch knobs.
Pulled switch plate off and replaced thermostat switch and temperature sensor bulb assembly.
Reassembled and plugged in.
Unit works normal.

Removed the back - Saw the broken clips on the base of the dryer (the wires to the motor were pulling out because the motor was slipping).

Guessed that the parts were motor clips (no pix in the web site!)

Got the parts in post - they were identical except needed some rubber grips inside to hold tight (Used pieces of ... Read more bike tire inner tube cut to fit for this.) Attached clips. Works fine!!

(Son is an engineer - he found the problem. Husband is a retired doctor - he couldn't!! but together they
supplied the muscle)
Sue (67 years old)