ACR2303MFW4 Maytag Range - Overview

Diagrams for ACR2303MFW4

See every part. Know exactly what you need.

Parts for the ACR2303MFW4

$15.00

Drip Bowl - 6 Inch

★★★★★

(40)

Part #W10196406RW

If your element will not heat, there could be an issue with your drip bowl. This chrome drip bowl is 8 inches in diameter, and fits most electric ranges. Before you replace the drip bowl, make sure the element is turned off and cool to the touch. Installation is easy, just remove the element, replace the current drip bowl, and replace the...Read more

Read less

$16.07

Drip Bowl - 8 Inch

★★★★★

(18)

Part #W10196405RW

This part is located beneath the element and catches any spills.

$56.33

Surface Burner Element Switch, Large Burner

★★★★★

(56)

Part #WP3149400

This surface burner element switch is for an 8-inch surface burner on an oven, stove, or range. The element switch controls the heat of the surface burner. Disconnect power to your range before completing this repair because you will be working closely with electrical circuits. Remove the screws from back panel and the console, and remove...Read more

Read less

$75.13

Oven Sensor

★★★★★

(44)

Part #WPW10181986

This oven temperature sensor, for ranges, works together with the oven control board to measure and regulate the oven temperature. The sensor detects the temperature in the oven cavity. If the following symptoms occur, replacing the temperature sensor could be the solution: Little or no heat when baking, oven not heating evenly, oven will...Read more

Read less

$33.69

Range Receptacle Kit

★★★★★

(13)

Part #814399

This assembly of parts is a surface burner receptacle kit, and is used in conjunction with your range. The assembly comes with two wires, two wire nuts, two pieces of heat-shrink tubing, and the receptacle. If your element is not heating, you may need to replace your surface burner receptacle. The function of this part is to connect the s...Read more

Read less

$21.45

Screw

★★★★★

(6)

Part #W11233072

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

$27.36

Range Terminal Block

★★★★★

(20)

Part #WPW10245259

This part is for oven ranges, it connects individual wires and protects the device from electrical surges, voltages, and current. With this part, the house power is connected to the range wire harness. Some symptoms replacing the terminal block could be a solution for are little to no heat when baking, element will not heat and/or it will...Read more

Read less

$24.15

Touch-Up Paint - White

★★★★★

(7)

Part #72017

This touch-up paint can be used on a wide variety of household appliances. It is most often used on washers, dryer, refrigerators, dishwashers, ranges, freezers, trash compactors, or microwaves. It is an 18 ml, or.6 fluid ounces, bottle of touch-up paint. It also features a brush for easy application. This quick-drying, long-lasting paint...Read more

Read less

$51.95

Rack

★★★★★

(5)

Part #W11520287

This chrome-colored oven rack is designed to provide a stable and heat-resistant surface for cooking, baking, and broiling inside compatible range ovens. Engineered for durability, it fits a variety of models and withstands high temperatures and heavy use. Whether you're replacing a damaged rack or adding an extra one for increased cookin...Read more

Read less

$52.67

Infinite Switch - 6 Inch

★★★★★

(8)

Part #WP3148952

This part carries 5.2-6.6 amps.

$9.62

Range Rear Leveling Leg

Part #WPW10058460

Sold individually.

$36.85

Spray Paint - 12 oz. - White

★★★★★

(3)

Part #350930

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a pr...Read more

Read less

Questions And Answers for ACR2303MFW4

Ask our experts a question about this model and we'll get back to you as soon as possible!

Sort by:

Mike - For model number ACR2303MFW4

November 5, 2024

Burner light won’t shut off. 8523265 125v

Hi Mike, Thank you for your question. If the burner light will not turn off, one of the switches is defective and you will need to use a multimeter to check them for continuity. Before removing and testing the switches for continuity, unplug the range from the electrical outlet. Then inspect the wires near the switches for any signs of burning, or overheated wires, or terminals. If no issues are found, remove the switches in order to test them for continuity. Set the multimeter to the Rx1 setting and begin testing the switches. Start by touching the L1 and H1 terminals with the probes. Once you have completed that test, touch the probes to the L2 & H2 terminals. If your test results indicate that there is no continuity between one or both sets of terminals, you need a replacement infinite switch. We hope this helps!

$52.67

Infinite Switch - 6 Inch

$56.33

Surface Burner Element Switch, Large Burner

Was this helpful?

Cathy - For model number ACR2303MFW4

November 17, 2025

I need coils for an electric stove top.

Hi Cathy, thank you for your inquiry. The surface elements for your stove top, right front and left rear, part number PS12731181, and the right rear and left front, part number PS12731180, are compatible with your model number. Glad to be of help!

$77.75

ELMNT-SURF - (LEFT FRONT AND RIGHT REAR)

$77.75

ELMNT-SURF - (RIGHT FRONT AND LEFT REAR)

Was this helpful?

Common Symptoms of the ACR2303MFW4

How this model fails, and the parts that fix it.

Element will not heat

Fixed by
these parts

Show All

Little to no heat when baking

Oven not heating evenly

Show All

Little to no heat when broiling

Touchpad does not respond

Fixed by
these parts

Show All

Videos related to models starting with ACR2303MFW4

Watch our pros, then fix it yourself.

Replacing the Surface Burner Element Switch, Large Burner

Replacing the Drip Bowl - 6 Inch

Replacing the Oven Sensor

Replacing the Drip Bowl - 8 Inch

Replacing the Rack

Replacing the Door Gasket

Replacing the Range Terminal Block

Replacing the Range Receptacle Kit

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Drip bowls were rusty and rotting through

491 of 504 people found this instruction helpful.

Michael from Kings Park, NY
Really Easy
Less than 15 mins

I simply removed the elements and replaced the drip bowls with new ones. Put the elements back in and my stove looks %1000 better!

Other Parts Used:

Drip Bowl - 6 Inch

Drip Bowl - 8 Inch

Was this helpful?

Just Replaced Ole Drip Bowls.

379 of 395 people found this instruction helpful.

Roger from Osage Beach, MO
Really Easy
Less than 15 mins

Unplugged burners. . . . . Removed old bowls and replaced with new. . . . . . Plugged burners back in. However, I do want you to know that I could not believe the promptness of your service and the courteous customer service person that assisted me with my problem in selecting the correct drip bowls. You are definitely a unique compan ... Read more

Read less

Other Parts Used:

Drip Bowl - 8 Inch

Drip Bowl - 6 Inch

Was this helpful?

mice had made nests in the insulation wrap in the range

127 of 208 people found this instruction helpful.

Wendy from Red Hook, NY
Easy
More than 2 hours
Screw drivers

I numbered every part. ex: 1 L., for first part removed left side. I used a magic marker to circle the holes and wrote the number of screws used on the part, set the srews in a separete place, so that I new where these screws went to. The cleanup was pretty time consuming, but I was able to keep my stove, when every repairman I called to ... Read more

Read less

Was this helpful?