ACF422 Amana Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Light burned out in upper oven
0 of 1 people
found this instruction helpful.
-
Shirley from Las Vegas, NV
- Really Easy
- Less than 15 mins
Screwed in light bulb and glass protector
Was this helpful?
Thank you for voting!
oven light burnt out
3 of 10 people
found this instruction helpful.
-
William from Schwenksville, PA
- Easy
- Less than 15 mins
1. Unscrewed glass cover on bulb
2. Removed old bulb
3. Screwed in new bulb
4. Replaced glass cover
5. Mixed drink & baked cupcakes
2. Removed old bulb
3. Screwed in new bulb
4. Replaced glass cover
5. Mixed drink & baked cupcakes
Was this helpful?
Thank you for voting!
light bulb went out in my oven
2 of 7 people
found this instruction helpful.
-
Janet from Ada, MI
- Really Easy
- Less than 15 mins
My husband took the plastic cover off and took out old bulb and screwed in the new one. Then put the cover back on.
Was this helpful?
Thank you for voting!
Bulb Replacement
0 of 2 people
found this instruction helpful.
-
Judith from Phoenix, AZ
- Really Easy
- Less than 15 mins
I pulled down the wire around the glass cover. . . Released on end of the wire from its holder being careful to not let the glass cover drop. Unscrewed the bulb and replaced with replacement. Easy, easy.
Was this helpful?
Thank you for voting!
Light bulb failure
-
Grant from Alexandria, VA
- Really Easy
- Less than 15 mins
Received the part the day after ordering. Appreciated the quick service and repair took less than a minute.
Was this helpful?
Thank you for voting!
circuit breaker blew
-
Richard from Sarasota, FL
- Easy
- Less than 15 mins
-
Pliers, Screw drivers
I went to the source of power on the stove and noticed one of the terminals had come loose from the terminal block and had shorted out against the cover of the terminal junction. After prying the loose terminal off cover I ordered new terminal block and received it the 2nd day. I removed the old terminal block and replaced the part in abo
... Read more
ut 10 minutes..Thank you Parts Select for your easy to find diagrams and quick delivery.
Read less
Was this helpful?
Thank you for voting!
One of the burner wasn't light up.
-
Sam from Fairport, NY
- Really Easy
- Less than 15 mins
-
Screw drivers
The repair was very easy. It took me less than ten minutes. There were only five screws including two to hold heat element that I have to unscrew and transferred the old clip the screw onto new heat element.
Was this helpful?
Thank you for voting!
Burner stopped heating
-
Anna from Copperas Cove, TX
- Really Easy
- 15 - 30 mins
-
Pliers, Screw drivers
My husband did the repair. It was so easy that I could have done it. He had to remove 3 screws and then hook up the element. Nothing to it!!
Was this helpful?
Thank you for voting!
Stove Range Drawer Difficult to Open and Close
-
Hau from Burke, VA
- Easy
- 15 - 30 mins
-
Nutdriver
Insert one end of the railing into the slot in the back of the stove. Align the front end of the railing with the hole at the front of the stove. Align the roller with the hole. Secure the front end of the railing, roller ,and hole with the shoulder bolt using a 10mm wrench. Tighten just enough but don't over tighten.
Was this helpful?
Thank you for voting!
range installer broke a screw off & busted the plastic piece
-
Christina from West Des Moines, IA
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers
Had to screw off old terminal block & screw on new one
Was this helpful?
Thank you for voting!
Small burner burned out on cooktop.
-
Kevin from Hurricane, WV
- Really Easy
- 15 - 30 mins
-
Screw drivers
Pulled cooktop up on Counter top and unscrewed the screws around around the cook top lifting the glass top off to get to bad burner.then disconnected wires from old burner lifting burner out and sitting new burner down in the cut outs. I have used parts select for my refrigerator,microwave and oven I can't say enough about how great there
... Read more
website is as well as there service.they have made a customer out of me for life and I have turned a lot of friends on to the site and they love it as we'll.
Read less
Was this helpful?
Thank you for voting!
Burner Would,Nt Heat Up.
-
david from cleveland, TX
- Really Easy
- 15 - 30 mins
-
Screw drivers
Removed top of stove replaced heating element ,piece of cake.
Was this helpful?
Thank you for voting!
two of the burners went out
-
george from elk grove, CA
- Easy
- 1- 2 hours
-
Screw drivers
the burners were located underneath the glass top, but i had no instructions on how to remove the glass top, so i spent an hour taking every screw off. finally i realized the glass top lifts off from the front then the repair became super easy. hard part was replacing all the screws, lol
Was this helpful?
Thank you for voting!