A712 Maytag Washer - Parts

This glide and spring kit contains two three inch springs, four one inch square glides, and two tubes springs. This kit replaces older style round roller glides.

Sold Individually.

Found on the water inlet valve.

This hose can handle hot or cold water and is five feet long.

This injector sleeve bracket is white and made entirely of plastic. This is a side mounting style bracket.

This inlet hose washer, also known as a high pressure inlet hose washer, is used in washing machines, refrigerators, freezers, and dishwashers. The function of this part is to create a watertight seal in the appliance. If your gasket gets dry and brittle over time it will start to crack and will lose its function. In this case, it is impo...Read morertant to replace it. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance. As a safety precaution, remember to unplug your washer from the power source before beginning.

This washing machine injector hose runs from your washer's inlet to its injector. It is black and made of rubber. It is also available in an injector kit.

This injector tube seal is just over an inch in diameter. It is black in color and made of rubber.

10 - 16 x .375

This part is located near the tub's brake assembly.

This injector fill hose is nine inches long. It is black in color and made entirely of rubber.

This is a set of 2 tension springs.