My Orders
- Home
- 970-C98902-00
- Instructions
970-C98902-00 Kenmore Washer Dryer Combo - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Dryer still turned, but would not heat
54 of 80 people
found this instruction helpful.
-
CAROLE from MONTICELLO, AR
- A Bit Difficult
- 1- 2 hours
-
Nutdriver, Pliers, Screw drivers
Had to remove tub to get to rear wall to make the repair and then put it back together in reverse order.
Was this helpful?
Thank you for voting!
My heating element had gone out
3 of 3 people
found this instruction helpful.
-
Van from BLUFFDALE, UT
- Easy
- 1- 2 hours
-
Nutdriver, Screw drivers
Don’t do like I did and undo the drummer from the back of that thing pulled off the bearing
Was this helpful?
Thank you for voting!
Dryer would not heat at all.
2 of 4 people
found this instruction helpful.
-
ricky from okeechobee, FL
- Easy
- 1- 2 hours
-
Screw drivers
I watched the video you had. Did what the man said, checked out the parts, and orded the new ones. Then installed , as per video. It was Fun.
Was this helpful?
Thank you for voting!
Heater coil broken
-
Joan from Conway, SC
- Easy
- 30 - 60 mins
-
Screw drivers
Once the drum was removed it only took 10 min to remove and replace the coil. It took approx one hour to complete
Was this helpful?
Thank you for voting!
drum bearing broke and heating element also broke had 2 things to fix
-
robert from sugarloaf, PA
- Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers
took the front panel off the dryer by lifting the lid and tilting it back and letting it hang there removed two screws from front panel at top right and left side and one clip fastener from left side of panel lifted the panel up and out took belt
off of motor pulley by opening back panel loosen belt tightner by pulling to the right ... Read more takeing belt off motor pulley removed drum through front panel opening replaced drum bearing which is self explanitory changed heating element
by removing the power wiress from it removed the screws
from the back of dryer and replacd everything in reverse order WARNING MAKE SURE YOU DISCONNECT POWER I REPEAT MAKE SURE YOU DISCONNECT POWEr
off of motor pulley by opening back panel loosen belt tightner by pulling to the right ... Read more takeing belt off motor pulley removed drum through front panel opening replaced drum bearing which is self explanitory changed heating element
by removing the power wiress from it removed the screws
from the back of dryer and replacd everything in reverse order WARNING MAKE SURE YOU DISCONNECT POWER I REPEAT MAKE SURE YOU DISCONNECT POWEr
Read less
Was this helpful?
Thank you for voting!