9554NBK Makita Grinder - Parts

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.

This is a genuine Makita replacement part that has been sourced from the original manufacturer to be used with angle grinders and die grinders. The o-ring is commonly used to seat and support the drive gear bearing assembly. This item is sold as an individual replacement part.

This is an authentic manufacturer-sourced replacement part which is specially designed for use with Makita grinders. It helps to provide an air-tight seal for the bearing box, over time it may wear out and begin to crack eventually requiring a replacement. It is made of high-quality rubber and is sold individually.

This O-ring creates a tight seal within the spindle lock assembly, helping prevent oil leaks while keeping dust and debris out of the gearbox. Made from durable rubber and measuring approximately 0.25 × 0.25 × 0.25 inches, it supports reliable protection and long-lasting performance. Replacing a worn or damaged O-ring helps maintain proper sealing, protect internal components, and ensure smooth tool operation.

This is an authentic OEM approved replacement item commonly used on Makita power tools. Bearings have many useful applications that will differ depending on a tool. Ball bearings are designed to minimize friction between two rotating parts. Because they are under constant pressure. Over time due to heat and friction bearings would break d...Read moreown and would need to be replaced. Please note this is a sealed metal bearing that is sold individually.

This is an authentic Makita replacement part manufactured for use with angle grinders and circular saws. The sealed bearing is used to reduce friction between a rotating shaft and fixed housing or assembly. This bearing is often used to allow the spindle to rotate inside the gear box, but may have other uses. Please see model diagram for part location and usage. This bearing is sold individually.

This is available as an individual replacement part. The labyrinth ring attaches to the bearing box. When replacing this item a screwdriver might be required during the installation process. It is made of metal and will need to be replaced if it breaks. This is a genuine replacement part sourced from the original manufacturer for use with Makita grinders and planers.

This is a genuine item that is supplied directly from the original equipment manufacturer for Makita angle grinders. It is an identical replacement for a missing or a faulty switch lever that was installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this compo...Read morenent. This high-quality lever is made of durable metal and is sold individuallym keep in mind the hardware to secure it is sold separately.