9528 - Parts

This is an authentic replacement part manufactured for use with Ryobi snowthrowers. The grease plug is commonly used to seal the oil port on the auger\\\'s gearcase assembly. This grease plug is available as an individual replacement part, please see model diagram for associative parts.

It is a genuine item that is supplied directly from the original manufacturer for use with snowthrowers. The friction disc is an important component of the drive mechanism that helps to propel the equipment forward. Unfortunately, over time it may wear out or get damaged eventually requiring a replacement. If the friction disc is worn or ...Read moredamaged, the snowblower will move slowly, erratically or not move at all. Please make sure to check the diagrams of your model for the correct location and application of this part. Keep in mind this high-quality assembly is made of durable metal and is sold individually.

This #191938-1 (CB-408) Makita carbon brush set contains two individual carbon brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. This brush set will fit the Makita tools listed at the bottom of the page. • Worn brushes are often the cause...Read more of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

Bolt 3/8-16x.75 g5

This tank cap assembly is a genuine replacement part supplied directly from Husqvarna. It is compatible with many models of chainsaws. This assembly includes the cap and the holder (part 503578901). The cap is designed to keep fuel inside the tank, as well as prevent outside contaminants from entering the tank. The holder connects the cap to the tank. This assembly should be replaced if either part is damaged.

It is an authentic OEM sourced item which is specially produced for use with snowthrowers, generators, and rear engine riders made by Murray, Briggs & Stratton, Snapper, and Simplicity. The nut is made of metal and attaches to the starter switch. During replacement, it may require a wrench to help install this part correctly. It may becom...Read moree broken or stripped and will need to be replaced. This part is available as an individual replacement.

This is an authentic manufacturer made replacement part which is specially designed for use with Murry, Snapper, and Simplicity snow blowers. The scraper blade attaches to the bottom of the auger housing, to protect the housing and augers from ice and other debris. This part is made of durable plastic and is sold individually. Before inst...Read moreallation, be sure to remove the ignition key. You will need a socket wrench to aid you in this repair.

Snow clean out tool with brush

Bushing-1.135idx1.62