My Orders
919-16552 (1) Craftsman Compressor - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
The air was bypassing the compressor gaskets and cylinder wall was worn out
18 of 24 people
found this instruction helpful.
-
Charles from GARRISON, TX
- Easy
- 30 - 60 mins
-
Screw drivers, Socket set
1 remove cover
2 unhook air line to tank
3 remove head bolts
4 remove intake from head
5 remove flywheel bolt to free up pump piston
6 remove screw on top of piston to change out gasket
7 remove the cylinder sleeve install piston from the top
8 reassemble piston rod end and the flywheel
9 on th ... Read more e head cover are two gaskets one on top and one on the bottom head
10 insert intake piece and bolt the head cover back in place
11 reinstall the air line and unit cover and secure with three cover screws
2 unhook air line to tank
3 remove head bolts
4 remove intake from head
5 remove flywheel bolt to free up pump piston
6 remove screw on top of piston to change out gasket
7 remove the cylinder sleeve install piston from the top
8 reassemble piston rod end and the flywheel
9 on th ... Read more e head cover are two gaskets one on top and one on the bottom head
10 insert intake piece and bolt the head cover back in place
11 reinstall the air line and unit cover and secure with three cover screws
Read less
Was this helpful?
Thank you for voting!
Can't find this special screw used on many housings etc
4 of 6 people
found this instruction helpful.
-
Tim from Tucson, AZ
- Very Easy
- 15 - 30 mins
Actually don't like using Torx bits because they are hard to center deep in the channel. I had misplaced these forcing me to order replacements.
My plan is to insert Torx bits before screwing in and using jb weld to secure the bit to the screw, giving me a hex head. Can't find this special screw with a hex head. This screw is called ... Read more AGC-408 by craftsman.
My plan is to insert Torx bits before screwing in and using jb weld to secure the bit to the screw, giving me a hex head. Can't find this special screw with a hex head. This screw is called ... Read more AGC-408 by craftsman.
Read less
Was this helpful?
Thank you for voting!
Broken ground on original plug
2 of 2 people
found this instruction helpful.
-
Debra from PRESCOTT VLY, AZ
- Really Easy
- 15 - 30 mins
-
Screw drivers
Removed cover & old cord.
Replaced with new cord & replaced cover.
Works perfect.
Replaced with new cord & replaced cover.
Works perfect.
Was this helpful?
Thank you for voting!