My Orders
- Home
- 8TWFC6820LC0
- Instructions
8TWFC6820LC0 Whirlpool Washer Dryer Combo - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Scratches in Surface
83 of 227 people
found this instruction helpful.
-
Michelle from Richardson, TX
- Really Easy
- Less than 15 mins
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.
Was this helpful?
Thank you for voting!
It took two of us to hold the ring and slide it on around the opening with the assistance of screwdrivers the spring was very tight
6 of 7 people
found this instruction helpful.
-
Terry from JUPITER, FL
- A Bit Difficult
- Less than 15 mins
-
Screw drivers
Two people to screwdrivers, stretching the spring out and around and that’s the last part to go on
Was this helpful?
Thank you for voting!
Washer hoses due for replacement
3 of 5 people
found this instruction helpful.
-
James from PINE MOUNTAIN, GA
- Easy
- 30 - 60 mins
Replaced each hose. Did discover that either hose can be used for hot or cold water lines. No longer required to label hot and cold replacement hoses.
Was this helpful?
Thank you for voting!
Both outside door handles turned very beige
23 of 76 people
found this instruction helpful.
-
Howard from Boynton Beach, FL
- Easy
- 30 - 60 mins
-
Nutdriver
Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discol
... Read more
oring refer handles. Thank you
Read less
Was this helpful?
Thank you for voting!
Washer Would Drain But Not Spin
0 of 31 people
found this instruction helpful.
-
Nelson from Middletown, NY
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers, Wrench (Adjustable)
Removed rear cover (6 screws) unpluged harness from motor control and removed same. Replaced motor control reinstalled harness. Replaced rear cover. Parts used motor control board.
Was this helpful?
Thank you for voting!