8ED20Z Whirlpool Refrigerator - Parts

This screw is sold individually.

Sold individually.

This part screws into the side of the wall in your fresh food compartment and supports a shelf.

The light socket in your refrigerator houses the light bulb and connects it to the power source. If your refrigerator light is not coming on when you open the door, you may need to replace the light socket. Before you replace the light socket, be sure that your light bulb is in working condition, as this may solve the same problem. This l...Read moreight socket kit comes with 2 wire connectors, a light shield, and the new socket. The wire connectors that come with this kit are included so your new socket can replace a variety of old ones. If this light socket is different than your original, you will need to use the connectors to make it fit your refrigerator. Be sure to follow the instructions provided, so this part will fit your refrigerator properly.

Sold individually.

This is a push-on start relay for your refrigerator. It attaches to the compressor and starts it by briefly boosting it. It will then shut off as soon as the motor is up to the required speed. You may need a new relay if your appliance is too warm or will not start. The tools you will need to make this repair include a flat-blade screwdri...Read morever and a pair of needle-nose pliers. This start relay measures to be just over one square inch.

NOTE: As per the manufacture the part does not come threaded. A self tapping screw will need to be used to make threads.

Sold individually.

This part may be too long for your appliance and may need to be cut to fit your specific dimensions.

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tra...Read morey can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Sold Individually - Appliance originally takes 2.

This part includes 2 shelf support studs.