8965 - Parts

This flat washer is an OEM part that is silver in color, made of metal, and its job in your equipment is to spread load and pressure under a bolt. It can have multiple uses depending on your equipment, and can be used in a lot of different equipment, so be sure to consult your owners manual or check your part number to ensure this fits yo...Read moreur model. Over time the washer may become damaged; watch for cupping from over-tightening as a leading cause. This is a very easy part to repair and does not require any tools.

This is a genuine manufacturer-sourced component which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is an identical replacement for a missing or faulty nut that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for ...Read morethe correct location and application of this item. Keep in mind this high-quality part is made of durable plastic and is sold individually.

This is a Briggs & Stratton and Toro replacement part directly sourced from the manufacturer for use in engines, generators, tillers, blower-vacuums, and lawn mowers. The breather assembly is made of metal and helps to vent the air from the engine. It might require a socket set, a set of pliers, and a screwdriver to replace this part if i...Read moret becomes broken. The part is sold individually but also includes the gasket-breather.

This insulation measures 2.5" thick, 33" wide and 70" long.

The brush holder assembly in your generator keeps the brushes in place, allowing them to touch the rotor. It consists of a plastic brush holder and two carbon brushes with lead wires and attached springs. You can usually find the holder assembly inside the generator housing, near the rotor and stator assembly. If the holder assembly is br...Read moreoken, it can cause improper electrical contact between the brushes and the rotor, leading to a loss of electrical current transfer. Additionally, over time, the brushes will wear down from use, resulting in inconsistent contact with the rotor. Look for visible signs of damage like cracks, breaks, or deformations in the holder. A damaged holder can cause unstable voltage, power surges, or your generator failing to generate electricity altogether. To remove the existing brush holder assembly from your generator, refer to your user guide for detailed instructions. It may involve removing a cover or access panel to reach it. Use a nut driver or suitable tool to disconnect the assembly from the rear-bearing carrier and any connected wires. Remember to magnetize the brush assembly and conduct a generator test after installing the new one. Please keep in mind that this authentic OEM part is sold individually.

Temperature control knob lets you control the temperature setting.

This is an authentic replacement item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is the special mechanism which allows a user to pull-start the engine, over time components may wear out and begin to fail eventually requirin...Read moreg a replacement. It is a high-quality assembly which includes a durable plastic housing, the starter spring, the pulley, the starter rope with the grip and the hardware to secure the housing.

This manufacturer approved replacement part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It is utilized to keep the oil in the tank. Please note this durable plastic oil fill cap is sold individually.

This is sold as a set that contains three rings. The rings attach to the piston and help to create a seal. When replacing these parts a screwdriver, a set of pliers, and a socket set might all be required during the installation process. These parts are made out of metal and will need to be replaced if they break or bend. They are authent...Read moreic Briggs & Stratton and Toro replacement parts that are sourced from the original manufacturer for use with engines, generators, tillers, and blower-vacuums.