893P Porter Cable Router - Parts

This is a Genuine Manufacturer Approved replacement part used on some Routers. This part provides the firm grip for holding a bit in a tool. This Collet is for using bits with 1/4" arbors. Due to prolonged, heavy use a collet may need to be replaced. Collet Nut is included in this Assembly.

This is an original part from Porter Cable. The metal pin is compatible with many router and saw devices, and is sold individually. This item is often used to as a guide to secure the casing. Please refer to manual for safety and repair instructions.

This is an authentic OEM sourced replacement 1/2 inch collet. It is specially designed for use with Black and Decker and Porter Cable routers. This part allows user to secure bits with 1/2 inch arbors only. It is made out of metal and is sold individually. Please note the collet nut is sold separately. To replace this item you will need a wrench.

It is a genuine item which is made for use with Porter Cable power tool. This part is supplied directly from the original equipment manufacturer. It is a special component which helps to connect two lead wires. The part is utilized to connect the on/off switch to the tool. It is a simple plastic item which is sold individually. Replacing ...Read moreit will only require a screwdriver, take apart the housing, remove the old part and secure the wires using the new connector.

A genuine replacement part that is supplied directly from the original equipment manufacturer for use with Porter Cable and Black and Decker power tools. It is a special pin which helps to secure the components together, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this ha...Read morerdware. Keep in mind this high-quality item is made of durable metal and is sold individually.

This is a genuine replacement part manufactured for use is power tools. This versatile steel washer has many applications. Usually this type of washer is used when fastening two components of a tool together with a nut and bolt. This washer is sold individually, please see model diagram for part location and usage.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling ...Read more - O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression - O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening - O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking - O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.