My Orders
867822 Kenmore Air Conditioner - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Old switch was difficult to remove and the push nuts provided with the new switch were too small to fit on the lid posts.
1 of 3 people
found this instruction helpful.
-
Chris from Wellesley, MA
- A Bit Difficult
- 1- 2 hours
-
Pliers, Screw drivers
Removed the old switch by essentially destroying it with a screw drive and pliers. Had to drive to the hardware store to purchase push nuts that fit.
.
.
Was this helpful?
Thank you for voting!
The plastic holding the Switch for fan/light broke
0 of 1 people
found this instruction helpful.
-
Roger from Lebanon, TN
- A Bit Difficult
- 15 - 30 mins
-
Nutdriver, Pliers, Screw drivers
A little difficult getting the old retaining washers off of the old part and placing the new washers on the new switch. I ended up using a nutdriver on the retaining nut and hitting it with a hammer. This worked great!! Make sure to record which wire color goes where on the old switch before removing wires. TURN OFF POWER BEFORE!! Th
... Read more
is is 220V. It can hurt you bad.
Read less
Was this helpful?
Thank you for voting!
Toggle switch was burned
0 of 2 people
found this instruction helpful.
-
Jian from Schenectady, NY
- Easy
- 30 - 60 mins
-
Screw drivers, Wrench set
The toggle switch I ordered is a little different then the original one. The original one has three head and one of the head is shared by two circles controlled by the switch. The switch I ordered has 4 head which mean it has two separate circles. I had to short circle the two middle heads to make it work. Other than this, the switch work
... Read more
s perfectly!
Read less
Was this helpful?
Thank you for voting!