8640 - Parts

This idler pulley wheel is just over two inches in diameter. It is all white in color and it is made entirely of plastic.

Sold individually.

This kit includes the switch and mounting clip.

This dryer drum glide is almost six inches long and is blue in color. This glide is made of plastic and is designated for the left side of some clothes dryers. This glide is also available as part of a glide kit, part number PS177273.

This is an OEM part that is made of metal and sold individually. The leveling leg is generally used with refrigerators, dryers, freezers, ranges, cooktops, and microwaves. The leveling leg is meant to keep your appliance steady and level to the floor. If you notice your appliance is uneven to the floor it may need to have the leveling leg...Read more replaced. You will notice that the bottom of the leveling leg has a smooth surface to ensure moving your appliance does not require as much effort. This part screws into a pre-drilled hole underneath the appliance.

This genuine OEM lint duct housing is located inside your dryer, covering the lint filter. It secures and supports the lint screen within the exhaust system. If the housing is cracked or loose and cannot catch lint effectively, it needs replacement. A damaged housing reduces drying efficiency, resulting in longer drying times, increased e...Read morenergy consumption, and higher utility costs. To replace it, consult the included instruction sheet. Open the dryer door, pull out the lint filter, and remove the screws below the door opening. Close the door and take off the front panel, placing it face down on a padded surface. Remove the blower seal from the front panel. Carefully pry outward on the top corners of the collector duct to disconnect it from the front panel. Once the top is clear, pull out and lift to release the lower locking tab from the front panel slot. This will free the assembly. Note that this replacement part does not include the duct seal, the blower seal, or the lint screen itself, so consider this before purchasing.

This front panel clip is just about an inch long. It is green in color and is made of metal. This clip is intended for use with the front panels of washers and dryers.

This dryer drum glide is just under seven inches long. It is all blue in color and is made of a hard plastic. This front drum support is intended for use with the right side of clothes dryers.

This dryer door switch contains three metal terminals. It is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

This gas conversion kit converts a natural gas clothes dryer to a L.P clothes dryer. This kit contains a blocking plug, a burner orifice, a caution label, a rating label, and an instructions sheet.

Sold individually.