Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The grommets came apart metal from rubber.
I replaced the broken grommets with the new ones. I purchased 8 so I would have back ups because I did not feel the new one would last either. I think they cost TOO MUCH but I could not haggle for price.
saw burner tube was completely rusted at end and would not line up with burner. decided to go ahead and replace all three tubes. was easy to install, able to get a good cleaning job on unit in the process. works fine, wife is happy and that is what matters in a motorhome.
Pull knob off igniter shaft, remove two screws, take out igniter, unplug wire. Reverse to install. Would have been very simple except the metal insert that is supposed to be inside the new knob was missing from the kit. I tried using the old insert in the new knob but it did not fit tight enough and would spin on the shaft. Had to use the old worn knob on the new igniter. Customer service said they don't carry the inserts. What? The brand new knob is useless! Needed to get the stove fixed so I didn't bother returning the entire kit. Oh well, stove works now!
igniter not working on magic chef stove on 60 foot yacht
called and ordered the part. it arrived the next day. amazing. put it in and all was well./ another happy yacht owner. Tim Wiest Tim Wiest yacht Service
This is a small RV cooktop. There is no pilot light but each burner will light using the spark type ingitor twist knob. Raise the front of the stove cooktop. It is on a hinge. Replace the ignitor assembly using existing screws. There is a very small anchor pin on the ignitor assy. which protrudes 1/16" from the base. The anchor pin hole had not been drilled into the stove face plate which prevents the ignitor assembly from twisting when engaged. So I drilled a 3/16 anchor pin hole exactly where required. It is important to be exact so as to align the installation screw holes in the face plate. These holes can be enlarged if need be however. Align the pin with the anchor hole and install the 2 existing screws. Attach the ignitor lead to the ignitor assy. and install the new knob. Close the stove top and start cooking.
easy replaced after giving proper model and serial numbers. They were very helpful sending pictures so i could choose which knob might work as they had two for the same model number. The person answering my call was very helpful. Also return of the wrong ones I ordered was easy and refund prompt. I would highly recommend this company.Gail from Mo.
I removed the igniter cable from the old knob. Removed 2 screws and the old knob, installed the new knob with 2 screws and plugged in the igniter cable. Works like a CHAMP!!! Must be an Oklahoma State University Football igniter and knob!! 2001 Big 12 Champions!!!!!