8527 - Parts

This wheel is sold individually - purchase quantity needed.

Sold individually.

This chute base, also known as a discharge chute base, is sourced from the original manufacturer for use with snowblowers. It is found at the end of the discharge chute which is responsible for directing the discharge of snow, or other materials that are being thrown by the equipment. The chute base is found at the end of the discharge ch...Read moreute where it acts as a connection point between the chute and the auger housing. The chute base aids in directing the discharge to a specific place, as well as controlling how far the discharge is thrown. If the chute base becomes damaged, cracked, or worn out, it will need to be replaced. A faulty chute base will result in snow being thrown haphazardly, not being thrown far enough or not thrown at all. It can also create blockages in the equipment, leading to potentially expensive repairs. Remove the fasteners that secure the base to the equipment and pull off the old chute base. Align the new chute with the mounting bracket and secure it with the fasteners.

This genuine replacement part is sourced directly from original manufacturer. It is used on a variety of lawn mowers. This is the knob that helps to secure the upper handle. It is made out of plastic and it is sold individually. When replacing this know you will need a screwdriver for the screw securing the knob.

This speed nut is designed for your refrigerator/freezer. The part is approximately 1/2 inch in length and 1/2 inch in width. This part is made of black plastic and has a round hole in the middle that is approximately 1/4 inch in diameter. This part is sold individually. This speed nut is an OEM part sourced directly from the manufacturer.

This light socket is two inches long. It is made of plastic and is white in color. It has two metal terminals extending from its base.

Sold Individually.

This black screw is well under an inch long, and is made of metal. It is used for many air conditioners, refrigerators, and ranges.

This manufacturer approved replacement part is designed for snow blowers/throwers. Skid shoe/plate allows you to avoid damage and keep smooth control over cracks, gravel, and other uneven surfaces. It is made out of metal and it is sold individually. Please note the right skid plate is sold separately. It is advised to replace both skid ...Read moreplates at the same time. To complete this repair you will need a wrench. • First remove bolts holding old skid plate • Remove old plate and insert new skid plate • Level snow blower and adjust skid plates to desired height • Tighten skid plate bolts

The deflector spring is made of metal and attaches to the deflector assembly. This spring is available as an individual replacement part. It will need replacement if it becomes stretched or broken. It is used in Husqvarna, Poulan, and Jonsered snowblowers and is an OEM from the manufacturer.

This replacement scraper bar is an authentic OEM supplied item that is commonly utilized on Poulan and Husqvarna snow throwers. It is secured behind augers to scrape up the snow that is left behind. This durable metal item is sold individually, please note the hardware to secure this bar is sold separately. You should only need a wrench to replace this part.

This shear bolt secures the snowblower auger to the drive shaft while acting as a built-in safety feature. Designed to break under excessive force, it helps protect the gearbox and engine from damage if the auger hits a hard object. Replacing a broken or missing bolt restores proper auger operation and ensures reliable, safe performance.