851513 Kohler Engine - Parts

Throttle Cable Clamp

Gasket, carburetor

Valve, exhaust oversized (.25)

This item is available as an individual replacement part. The screw attaches to the ignition module and is made of metal. If this item becomes stripped or broken it will need to be replaced and may require a wrench during the installation. This is an OEM part sourced directly from the manufacturer and used in engines made by Kohler and Toro.

A genuine item that is supplied directly from the original equipment manufacturer for use with Kohler engines commonly installed on lawn and garden equipment. It is a special replacement for a missing or worn o-ring which is utilized to provide a tight seal for the lower oil fill tube, make sure to refer to the appropriate diagrams of you...Read morer model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable rubber and is sold individually.

This genuine manufacturer-sourced part is specially designed for use with Kohler engines that are commonly installed on lawn and garden equipment. It is an important component which provides a tight seal for the governor cross shaft. If the seal is worn, damaged or missing, this will provide an identical replacement for the original part ...Read morethat was installed on a new unit. To ensure the correct repair procedure, check the diagrams for your model. Note, this high-quality seal is made of durable material and is sold individually.

This replacement spring-linkage is an authentic OEM component which is Kohler engines that are commonly installed on a variety of lawn and garden equipment. The spring connects governor lever applying tension on the part and allowing it to retract. Over time it may wear out or get damaged eventually requiring a replacement to ensure your ...Read moreequipment functions properly. Note, this high-quality spring-linkage is made of durable metal and is sold individually. You will need pliers to remove the old part and secure the new one. Refer to the appropriate diagrams of your specific model for the exact location of this component.

This item is sold individually and is made of metal. The screw attaches to the rocker cover. It may require a wrench during installation and will need to be replaced if it becomes stripped or broken. This is an authentic part from Kohler and Toro for use in engines.

O-ring