Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Broke the round glass tray
10 of 14 peoplefound this instruction helpful.
Eileen from DETROIT LAKES, MN
Very Easy
Less than 15 mins
new glass tray
Was this helpful?
Thank you for voting!
One of the switches in a component that door activates when shut.
9 of 11 peoplefound this instruction helpful.
Jimmy from OZARK, MO
Easy
30 - 60 mins
Pliers, Screw drivers
I replaced the whole component with all three switches in it even though only one switch was bad . Taking out one switch out of the holder unit would probably have damaged the unit that was holding the switches. Easy install and it works great again .
Was this helpful?
Thank you for voting!
would not start.
8 of 10 peoplefound this instruction helpful.
James from VIRGINIA BCH, VA
Really Easy
30 - 60 mins
Screw drivers
diagnosed defective 'door-shut switch' in the switch holder assembly. rather than replace switch, replaced entire locker holder assembly which made for a very simple and easy repair...not to mention very inexpensive.
Was this helpful?
Thank you for voting!
The glass was cracked and the turntable burned
7 of 8 peoplefound this instruction helpful.
Doris from BRONX, NY
Very Easy
Less than 15 mins
Just removed and replaced by putting the new turntable and glass in, 1, 2, 3; that's it. I'm so thankful for this site because I would have had to buy a whole new microwave. Thanks a million!
Not knowing which of the switches to replace I ordered all three in the assembly. Replacing the full assembly was easy, first unplug the microwave. Then remove the top cover to access the screws that hold the control panel in place and let the control panel hang. There are two screws that hold the assembly in place - remove those. I u
... Read moresed needle nose pliers to pull the wires off of the switches and immediately put the wires on to the new assembly so there was no confusion on what wire went where. Place the assembly back in position, replace the two screws to hold it in, put control panel in place and secure screws. Replace top cover and plug in.
Read less
Was this helpful?
Thank you for voting!
food does not get hot, carousel did not turn, all other indicators worked
3 of 3 peoplefound this instruction helpful.
John from SEVERN, MD
Really Easy
30 - 60 mins
Screw drivers
Read the troubleshooting section on this site. Figured it was an interlock problem because the food was not getting hot (magentron not turning on) and the carousel was not turning. Did not think both the carousel motor and magnetron failed at same time, thus indicated an interlock problem. The interlock switches are actuated by the door
... Read morelatch. Replaced the assembly locker piece with all three switches (only a $20 dollar part) and microwave was fully operational again. Wife and kids think I am a hero.
Read less
Was this helpful?
Thank you for voting!
UNABLE TO INSTALL DUE TO DAMAGED IN SHIPPING
3 of 4 peoplefound this instruction helpful.
Tina from EL DORADO, KS
Very Difficult
More than 2 hours
WORTHLESS...I EMAILED YOU ON 2/7/22 AFTER RECEIVING THE DAMAGED FILTER DUE TO NOT SHIPPING IN A HARD OR SOMETHING IN THE ENVELOPE TO PROTECT THE FILTER FROM BEING BENT. I HAVE NOT HAD ANY RESPONSE FROM YOU FOR THE DAMAGED FILTER OR WHEN I CAN EXPECT ONE THAT I CAN USE. UNSATISIFACTORY SERVICE!
Was this helpful?
Thank you for voting!
Replacing top vent filter
2 of 3 peoplefound this instruction helpful.
Paul from CHARLOTTESVLE, VA
Very Easy
15 - 30 mins
Screw drivers
Followed owners manual instructions to the letter: removed two top screws, opened the unit door so I could slide out the old filter. We don’t cook much at all in the unit, mostly just heating coffee and reheating leftovers. BUT! The top grill was pretty greasy and needed hot soapy water to clean, including in the depths of the top area. T
... Read morehe whole process, especially the company website for part ID and purchase, was slick!
Read less
Was this helpful?
Thank you for voting!
Air Filter Replacement
1 personfound this instruction helpful.
Claude from PARK CITY, UT
Very Easy
Less than 15 mins
Originally called it "grease filter" until I found very small print "air filter" on damaged original. Part #PS3527528
Slipped into place with ease -- right bottom of microwave
Was this helpful?
Thank you for voting!
Change the Charcoal Filter and Microwave Grease Filter (Normal Maintenance)
1 personfound this instruction helpful.
Lynwood from GONZALES, LA
Very Easy
Less than 15 mins
Screw drivers
Both were easy to replace. I followed the instructions in the users manual which came with the microwave. On the grease filter, I removed the 2 Phillips head screws which hold the grill plate in place. I had to open the microwave all the way to remove the grill plate. The grease filter was easy to remove and replace with a new one. I then
... Read more put the grill back in and secured it with the 2 screws. Easy Peasy!
Received my replacement Tray,Glass in only 2 days. Opened it and placed it in the Microwave. Yep, it was that easy!
Was this helpful?
Thank you for voting!
Light bulb burned out
Craig from Burke, VA
Really Easy
Less than 15 mins
Screw drivers
I unscrewed the light cover, removed the burned out light bulb and replaced it with one I ordered on Partselect.com. It was very easy.
Was this helpful?
Thank you for voting!
No Heat
Dennis from Chesapeake, VA
Really Easy
15 - 30 mins
Screw drivers
1. Removed unit from the cabinet. (2 screws). 2. Remove the outer microwave metal shell. (10 screws). 3. Locate and remove part. (3 screws). 4. Install new part and replace all screws. 5. Install unit back into cabinet. So easy. I will share this site with all of my friends.
My Orders
