Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Previous glass shelf shattered into a million pieces while cleaning.
1 personfound this instruction helpful.
Susan from SAFETY HARBOR, FL
Really Easy
Less than 15 mins
Just laid the shelf down. Fit like a glove!
Was this helpful?
Thank you for voting!
Old part did not seal properly
1 personfound this instruction helpful.
Donald from MERRITT IS, FL
Really Easy
Less than 15 mins
Screw drivers
Read the reviews from other members and just did as they said. Needed a screw driver and the info from past persons review couldn’t have been easier.
Was this helpful?
Thank you for voting!
Door light switch, 3rd one I have replaced in 6 years made in China.
1 personfound this instruction helpful.
Charles from CURWENSVILLE, PA
Really Easy
Less than 15 mins
Pliers, Screw drivers
Easy install, small screwdriver under back of old switch push out and pull out with small pliers. unsnap the old plug and install new. YOUR DONE
Was this helpful?
Thank you for voting!
door slight switch failed
1 personfound this instruction helpful.
Greg from CASA GRANDE, AZ
Really Easy
Less than 15 mins
Pliers
Covered the sidewall with tape to protect. Pried the switch out with knife blade and removed electric plug with needle nose pliers. placed plug in new switch and pushed switch into the hole in the side wall. Took about five minutes.
Was this helpful?
Thank you for voting!
Grandson tried to climb up inside of the refrigerator door ,
1 personfound this instruction helpful.
Dennis from FLORISSANT, CO
Really Easy
Less than 15 mins
thought the shelves looked like a ladder. Didn't work out well . Grandmother not happy.Ordered replacement shelf arrived quickly ,easily install Grammy happy and grandson out of the doghouse .Thankyou partselect!Removed damaged shelf ,installed new shelf no tools needed part was exact match
Was this helpful?
Thank you for voting!
The glass shattered & needed to be replaced
2 of 4 peoplefound this instruction helpful.
David from HAMPTON, GA
Very Easy
Less than 15 mins
Just popped it in, just as easy as that!
Was this helpful?
Thank you for voting!
The switch became intermittent - Possibly a poor designe
1 personfound this instruction helpful.
Sidney from ENDICOTT, NY
Very Easy
Less than 15 mins
Screw drivers
Used a small screw driver inserted into the front of the switch (facing the front) and pried until the switch was coming out. When out, I removed the connect harness and replace the switch with a new one.
Was this helpful?
Thank you for voting!
Lights didn't come on when door was opened
1 personfound this instruction helpful.
Philip from Ashland, MA
A Bit Difficult
15 - 30 mins
Pliers, Screw drivers
I have moderate to good mechanical skills, but getting the old switch out was a sizeable challenge. Since this switch suffered some damage during extraction, I was lucky to have ordered a new one to replace it. Reinstall took approximately 90 seconds. PartSelect saved me an expensive service call.
Was this helpful?
Thank you for voting!
Light quit coming on when door opened.
1 personfound this instruction helpful.
Calvin from Northome, MN
A Bit Difficult
15 - 30 mins
Screw drivers
Unplug from wall receptacle. Pry switch out with screwdriver while pushing on inner tab. Then disconnect electrical plug.
Was this helpful?
Thank you for voting!
The Ice maker stopped working
2 of 4 peoplefound this instruction helpful.
Joseph from SAINT LOUIS, MO
Really Easy
30 - 60 mins
Pliers, Screw drivers
Thanks to videos on You-Tube which showed step by step removal and replacement. It was a simple process. only thing missing on the video was information on the green ground wire.
Was this helpful?
Thank you for voting!
The original spring in the mullion door broke
1 personfound this instruction helpful.
John from ELLWOOD CITY, PA
Easy
30 - 60 mins
Screw drivers
I disconnected the refrigerator power, removed the 2 screws holding the mullion door on the left side of the refrigerator French-door (it’s the flap that allows the door to close). Removed the broken spring and installed the replacement spring in its place. Reinstalled the mullion door by putting it in place and installing the previously
... Read moreremoved screws.
Read less
Was this helpful?
Thank you for voting!
Broken sliding rails for vegetable and deli tray. Glass replacement for vegetable trays
2 of 4 peoplefound this instruction helpful.
Nancy from COUNCIL BLFS, IA
Very Easy
30 - 60 mins
Screw drivers
Removed trays and replaced broken sliding parts and replaced glass
The hose that feeds the Ice Maker broke,right where it goes in the Fridge.
2 of 4 peoplefound this instruction helpful.
William from BOWDOINHAM, ME
Easy
1- 2 hours
Screw drivers, Socket set
I actually didn't use what I got. Because there was all kinds of tubing coiled up in the door. We just fed the exsess all the way through the Fridge,and Bingo! It was done.
The glass was ordered correctly. The part was too big for mt refrigerator. I tried to send it back, but I got no reply. I tried cutting the glass to size and it shattered. I wasted 60.00 and im disgusted with your company.
Was this helpful?
Thank you for voting!
cannot get water to the icemaker
1 of 2 peoplefound this instruction helpful.
PAUL from AMARILLO, TX
Very Difficult
More than 2 hours
Nutdriver
i changed the filter and was able to get water to the white coil at the bottom of the dispenser (left door) but could never get water to the icemalker.i also replaced the pump at the bottom of the door as well as the green ebr699172 dispenser electrical board.still can not get water to the icemaker.any help will be greatly appreciated.<
... Read morebr />paul
My Orders
