8361 - Parts

This is a surface burner igniter, also known as a top burner ignitor and stove top spark electrode. It is used to generate the spark that lights the surface burner. If your stove will not start, element does not heat, or gas igniter glows but does not light, replacing the igniter can solve these issues. For this installation, you will nee...Read mored a Phillips screwdriver and needle nose pliers. First place the grate on top of the burner, then lift the burner and disconnect the wires. Next remove the two Phillips screws from the bottom of burner, pull igniter out of the burner and wiggle in the new one. Refer to the installation instructions provided by the manufacturer for more instructions.

This burner cap assembly is sold with the spark electrode igniter and has a 7-inch outer diameter. This manufacturer-approved surface burner is for gas ranges. The surface burner supplies the heat to a cooking area on the cooktop. You may need to replace your burner cap if the gas igniter glows but will ignite the flame, the range will no...Read moret start, or if you can smell gas. Because a faulty burner cap could lead to a house fire, it is recommended that you replace this part as soon as you realize it is faulty. Remember to unplug the range, turn off the gas, and let the unit cool down before starting this installation. Note: this part has been redesigned and no longer requires a gasket, and is sold individually.

The burner head cap with spark electrode directs the gas to the front and back burner heads and will equally distribute the gas across cooking areas. This part can help the following symptoms: if your oven will not start, element will not heat, the gas ignitor does not light, and/or gas spreads a smell. Make sure to rotate the burner asse...Read morembly clockwise to release the burner from the top. Please note: this part has been updated and the gasket seal is no longer required. Make sure to unplug the oven before installing this part and wear work gloves to protect your hands.

This part may differ in appearance, but functions same as original part. : This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

This top burner knob is just over two inches in diameter. It is black in color and is made of plastic. This knob has white lettering denoting the off, low, light, and high positions. It also has a red indicator line and a line of decorative red flames of various sized denoting the temperature level. This knob will accept a 'D' shaped shaft.

This burner knob is a little over two inches in diameter. It is a white knob and it is made of plastic. There is dark gray lettering on this knob denoting the off, warm, simmer, and high positions. Also, this knob has a red indicator line, and a red rectangle denoting the lite position.

Sold Individually.

This screw is sold individually.

This top burner knob is two inches in diameter. It is primarily a white knob with dark gray lettering denoting the off, low, lite, and high positions. This knob also has a red indicator line as well as decorative red 'flames' to denote the temperature level.

This square burner grate has sides measuring approximately nine inches. It is all black in color.

This igniter wire is twenty-eight inches long.