8312 - Parts

Transmission asmy

Grip

Cable clutch pull

Engine Pulley (25MM x 2-1/8 OD Yellow) Used on Kawasaki Engines.

Side Discharge Bracket

Support guard

This 0.25-inch-diameter washer with internal lock teeth is an authentic manufacturer replacement fastener used in outdoor power equipment. It has a flanged base, which provides even load distribution and protects the mounting surface from damage during installation and removal. The washer also has inward-facing teeth, providing additional...Read more grip to prevent the secured components from falling off the equipment. Over time, the washer will corrode, crack, or wear down its teeth, leading to equipment instability, noise, and vibrations. Inspect all the washers in your equipment and replace those that are no longer functional. Use a wrench or socket to loosen and remove the old washer, and then position the new one on the mounting surface. Tighten the washer until the flange rests flush against the surface. Each washer is sold individually.

This is a genuine Snapper part sourced directly from the manufacturer for use in steel deck series. The pulley attaches to the hex shaft and is made of metal. It may require a wrench set during installation. It will need to be replaced if it breaks. This item is sold individually.

This is an OEM part sourced directly from Snapper. The Latch is used to allow height adjustment on the wheels of many models of Snapper Lawn Mowers. This is a fully metal part, and is sold individually. You will need a small monkey wrench or socket wrench to remove the nut and bolt (not included) to replace this part.

This differential bearing is an OEM part from the Snapper manufacturer. This item is constructed of high-quality metal, and is compatible with many lawn mower machines. The differential bearing is fitted in the housing assembly, securing the short axle. This part is sold individually. A wrench set and pliers are often needed in the repair.