831017 - Overview

This roll pin is a genuine OEM part that is designed for use with various makes and models of snowblowers and lawn tractor snowblower attachments. Made of metal and sold as an individual part, this pin features a 0.25-inch diameter and 1.75-inch length. This pin is hollow and features a split lengthwise down the middle to allow it to fit ...Read morewithin tighter spaces and reduce the movement between two parts, such as the shaft or axle. If your snowblower is not performing well or has seen a decrease in power, check to make sure the roll pin is not damaged. To remove and install a new roll pin, you will need a hammer and a punch, and will simply need to punch out the old pin and punch in the new one.

This OEM part is a zerk fitting that is sometimes called a grease fitting, lube fitting, grease zerk, or Alemite fitting. It is a metal nipple that you connect a grease gun to, allowing you to lubricate the moving parts in your lawn equipment, usually on joints or bearings. This fitting is 1/4 inch wide, has 28 threads per inch, and a thr...Read moreeaded portion that is .256 inches long. If the fitting is broken, you may notice that your machine is moving sluggishly, or the fitting may appear cracked or clogged with debris. It is important to replace a damaged fitting right away, because if you do not, debris can prevent the fitting from accepting grease and the moving parts of your machine will wear out faster and eventually break down completely. To replace the fitting, you will need to use a wrench to remove it from your machine. Keep in mind that this replacement part is sold separately, so you may want to consider stocking up on fittings before you need them. Since the fittings on your machine wear out at the same rate, having a few extra on hand can save you time and hassle down the road.

This is an original part from the Ariens manufacturer. The cotter pin (1/8 x 1 plated) is made of durable metal, and is compatible with many snowblower machines. This component is often used to secure the chute crank. The cotter pin is sold individually. Please be sure to refer to specific manual and diagrams for repair instructions. A screwdriver may be helpful in making the replacement.

May Require 54140 With1 7/8 O.D.

Nut

This is an authentic manufacturer sourced replacement washer that is commonly utilized on Ariens snowblowers. It helps to distribute the pressure evenly between two connected parts, for correct location and use of this hardware please refer to appropriate diagrams of your unit. This part is made of durable metal and it is sold individually.