82829 ((HT18480)(Series 4)) Snapper Lawn Tractor - Parts

This 0.25-inch-diameter washer with internal lock teeth is an authentic manufacturer replacement fastener used in outdoor power equipment. It has a flanged base, which provides even load distribution and protects the mounting surface from damage during installation and removal. The washer also has inward-facing teeth, providing additional...Read more grip to prevent the secured components from falling off the equipment. Over time, the washer will corrode, crack, or wear down its teeth, leading to equipment instability, noise, and vibrations. Inspect all the washers in your equipment and replace those that are no longer functional. Use a wrench or socket to loosen and remove the old washer, and then position the new one on the mounting surface. Tighten the washer until the flange rests flush against the surface. Each washer is sold individually.

This is a genuine replacement part sourced directly from the manufacturer. The straight lube fitting is commonly found in riding mowers and snowblowers from Snapper and Murray. This part is made of metal, and is generally placed in the hub of the wheel assembly to allow the axle to be lubricated. This item is sold as an individual replacement part.

This is an OEM part sourced directly from the manufacturer. The frame bushing is designed for use in lawn tractors from Snapper and Simplicity. This part is made of metal, and is placed in the sides of the frame to allow components to move easily. You may require a wrench when replacing this part. This item is sold individually.

Bolt carriage

The screw attaches the steel blade to the blade hub. It is a genuine OEM sourced part which is specifically designed for use with lawn mowers made by Murray, Briggs & Stratton, Snapper, and Simplicity. This part is available as an individual replacement part and is made of metal. It will require replacing if it strips or breaks and when replacing this part a wrench will be needed.

It is a genuine item that is supplied directly from the original manufacturer for use with Murray and Snapper lawn and garden equipment. A washer is generally utilized to provide a tight seal between connected components. It is an identical replacement for a missing or a faulty hardware that was installed on a new unit. Make sure to check...Read more the appropriate diagrams of your specific model for the exact location and application of this thrust washer. Keep in mind it is made of durable metal and is sold individually.

This is an authentic Snapper replacement part, sourced from the original manufacturer for use with riding lawnmowers. The metal washer is commonly used to provide spacing between the top of the spindle pulley and the nut that secures it. This item is available as an individual replacement part.

This is an OEM replacement part sourced directly from the manufacturer. The tolerance ring is commonly found in Snapper rear engine riders. This part is made of metal, and is wrapped around the spindle housing in the spindle assembly. This item is sold individually.