8235 - Parts

The metal screw attaches to the muff guard bracket. It is a genuine replacement part sourced from the original manufacturer for use with blowers, engines, generators, pressure washers, snowblowers, and vacuums made by Briggs & Stratton, Toro, and Lawn Boy. This item is available as an individual replacement part. When replacing this screw a wrench will be needed. It will need to be replaced if it strips or breaks.

This is an authentic Murray replacement part that has been sourced from the original manufacturer to be used with riding lawnmowers. The metal washer is used to provide spacing between the steering spindle and the front axle assembly. This item is sold individually, please note two washers may be needed.

This is an authentic replacement part manufactured for use with Snapper lawnmowers. The special nut is commonly used to fasten the bolt that goes through the rear wheel hub. This nut is available as an individual replacement part, please see the model diagram for associative parts.

This manufacturer-certified Grass Chute is a black plastic part used to direct grass clippings. Installation is rated as "Easy" by customers, and requires a wrench or socket. The chute secures to the top of the cutting deck. If broken due to wear/fatigue/damage you will be able to see the issue, and should replace the part. Refer to your make model and diagram to ensure this is the correct part.

This part is available individually and is made of plastic and metal. The limit switch connects to the interlock and helps to turn off the engine if there is a problem. A wrench might be required during the replacement of this part. It will require replacing if it becomes broken. This is a Murray, Snapper, and Simplicity replacement part directly sourced from the manufacturer for use in lawn tractors.

A genuine item which is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is a high-quality replacement for a missing or damaged cover for the ratchet clutch, please make sure to check the appropriate diagrams of your model for the correc...Read moret location and application of this hardware. Keep in mind this durable part is made of metal and is sold individually.

This is an authentic replacement part manufactured for use with Briggs & Stratton small engines. The special retainer is commonly used as spacing between the head of the valve and the valve spring. The retainer is available as an individual replacement part, please see model diagram for associative parts.

Roll pin 1/4x1-1/4

This is a genuine Briggs and Stratton part for use with Engine, Lawn Mowers, Snow Blowers, Leaf Blowers / Vacuums, Tillers, Generators, Lawn Tractors, and Chipper Shredders. The recoil starter ratchet clutch attaches to the starter reel and provides tension against the ratchet when starter rope is being pulled. The most common reason for ...Read morereplacing the recoil starter ratchet clutch is if broken or damaged. This part is sold individually.

This is a genuine part which is supplied directly from the original equipment manufacturer and is used with Craftsman lawn tractors. The solenoid support engages and routes the battery electrical supply to the engine starter when the ignition switch is turned to the start position. This part is made of hard plastic and metal, it is also s...Read moreold individually. The tools you will need for this repair are a screwdriver and socket wrench.

The fuel shut off valve attaches to the handle shutoff valve. This item is made of metal and is available as an individual replacement part. It might require a screwdriver and an adjustable wrench to replace this item if it becomes broken. This is an original Briggs & Stratton and Toro part for use in engines, snowthrowers, tillers, lawn mowers, and lawn tractors.

This is a genuine replacement part that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. The purpose of this cap is to keep the fuel in the tank, over time it may get damaged or lost eventually requiring a replacement. It is a high-quality component which is made of durable metal and it is sold individually.