8099 - Parts

This assembly is the tub, felt seal and 3 baffles in the tub.

This fuel tank gasket is an OEM part certified by the manufacturer, and it provides a seal on the gas tank and carburetor of your machine. This fuel tank gasket is gray in color and made of composite materials. It is sold individually and is not part of a kit or assembly. Over time, the gasket can become damaged due to fatigue or wear, ...Read moreor it can dry out and the seal will fail. If you notice fuel leaking from the fuel tank gasket, it is time to replace it. This is a medium-difficulty repair that requires a wrench, sockets, and a screwdriver. You will look to reinstall your new part between the carburetor and gas tank. Note that if your carburetor and tank are separated for any other repairs or maintenance, you will also need to replace your fuel tank gasket regardless of condition, as it is a one-time use.

This moisture sensor wire harness connects the sensor bars to the dryer’s control board, enabling accurate detection of fabric dampness to prevent over-drying and improve energy efficiency. Designed for a precise fit, this single harness ensures proper communication between the sensors and the control system, restoring optimal drying perf...Read moreormance when the original part fails. Common signs of failure include clothes remaining too wet or becoming over-dried. For safety, disconnect power before installation and follow manufacturer guidelines.

This grey drying rack fits inside your front load dryer. It is an accessory used to dry items that should not tumble, like shoes, stuffed animals, pillows, or other delicate items. It provides a stationary surface for these items to rest on while air circulates. The rack is 27 inches wide and can be attached inside the dryer drum. This genuine OEM rack is sold individually.

This OEM Oil Seal is an individually sold rubber part which is attached around the axis shaft on the crankcase housing to provide a proper seal. A broken seal will lead to a leak, and the part should be replaced. Installation is rated as "Medium" difficulty by customers, and will require a screwdriver, wrenchset and seal puller. Refer to ...Read moreyour make, model and diagrams to ensure you've chosen the correct part. This model comes in black and grey.

The Breather Gasket is OEM and used to provide an airtight seal for the breather assembly. It is a gray part, attached between the breather cap and engine. Installation is rated "Easy" and will require a wrench set and socket set. If broken, damaged, or worn due to fatigue, there may be oil leaking from it, and the engine may be running r...Read moreough from an unwanted vacuum sucking in air. If this happens, replace the part. Refer to your make, model and diagrams to ensure this is the correct part for you.

Also known as a belt switch.