EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

8046 - Overview

Models starting with 8046

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Oven Bake Element – Part Number: 316075103
$37.35
In Stock
Oven Bake Element
★★★★★
★★★★★
(521)
Part #316075103
The Oven Bake Element is a black, metal part which supplies heat to the oven. This element is 19-1/2" wide x 18-1/2" long and has 3-1/2" inserts. It is rated as "Easy" to install by users, and attaches to the bottom of the oven. If you notice visible damage, or that your oven is not receiving heat properly then it may be a problem with this part. Check your model number and user manual to see if this is the right part for you. It is important for you to disconnect your appliance from the power source before performing this repair. After disconnecting your appliance, remove the two screws/nuts connecting the old element, pull it out, and discard if faulty. Simply connect the new element prongs where the old element fit, and screw it back in. You may need a flashlight when making this repair.
Lower Spray Arm – Part Number: 5304517203
$44.14
In Stock
Lower Spray Arm
★★★★★
★★★★★
(153)
Part #5304517203
The Lower Spray Arm is used in your dishwasher to spray water and clean your dishes. If broken there will be visible damage or your dishes may no longer be cleaned properly. If your spray arm is broken (due to general wear or high heat), it should be replaced. Your lower spray arm will be located at the bottom of your dishwasher tub. Check your user manual and model number to ensure this model is right for you. This version is plastic and metal and comes in gray/blue. We recommend you wear work gloves to keep your hands safe when installing and disconnect power to the appliance. You will also want to make sure that you turn off the water supply to your dishwasher. From here, you will want to open the dishwasher, pull out the lower rack and set it aside. Remove the lower wash arm. On each side of the bottom of the spray arm, there are small locking tabs that can be pushed aside using a flathead screwdriver. Once released, the spray arm can easily be pulled off the dishwasher. Put the new lower wash arm in place and push it down to lock it in. Ensure it is spinning freely and does not hit the heating element. Return the lower dish rack into place and then close the dishwasher door.
Wheel & Bushing Assembly – Part Number: 5304532229
$11.99
In Stock
Wheel & Bushing Assembly
★★★★★
★★★★★
(25)
Part #5304532229
The single rack roller kit comes with one axle/clip and one wheel/roller. The rack wheel is designed to allow the rack of your dishwasher to roll in and out. If the rack will not complete this task, or you notice that your dishwasher is not cleaning dishes properly, you may need to replace the rack wheel. The single rack roller kit is made of white plastic, and clips to the dishwasher rack with the included axle/clip. Many of our customers have described this repair as easy, and you will not require any tools to complete it. Lower rack roller and bracket assembly, grey. Wheel has been updated. If wheel pictured is not like old one, you may need to replace all wheels.
Dishwasher Tub Gasket - Gray – Part Number: 154827601
No Longer Available
Dishwasher Tub Gasket - Gray
★★★★★
★★★★★
(52)
Part #154827601
This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing water leaking out. If broken, it should be replaced. Refer to your model number and user manual to ensure this part is right for you. When making this repair, open the dishwasher door and take out the lower dish tray for better access. Pull out the old gasket, and clean the channel with a rag. Push the new gasket into place into the notch on the door, which you should see upon close inspection, using a flat-head screwdriver for assistance if necessary. We do not recommend cutting any additional length off on the tub gasket if any is present during your repair.
Upper Spray Arm – Part Number: 5304506516
$34.38
In Stock
Upper Spray Arm
★★★★★
★★★★★
(74)
Part #5304506516
This spray arm is a genuine OEM replacement part for your dishwasher. This spray arm is for the upper part of your dishwasher. No tools are required for this repair, simple remove the rack stops and upper dish rack, then disassemble the mount and spray arm before installing the new one.
Infinite Burner Switch - Large Element – Part Number: 316436001
$51.29
In Stock
Infinite Burner Switch - Large Element
★★★★★
★★★★★
(87)
Part #316436001
The infinite burner switch controls the stove top eight-inch surface burner, which is the large surface element. If your surface element is not warming up, the element can be tested to determine whether or not it is defective. If your element is not defective, then it is more than likely that the infinite burner switch is the issue. Before you install the infinite burner switch you will need to unplug your range from the power supply, or shut off the home circuit breaker. The tools you will need to do this repair include a number one square head screwdriver and a pair of needle nose pliers.
Silverware Basket – Part Number: 5304535382
$32.95
In Stock
Silverware Basket
★★★★★
★★★★★
(36)
Part #5304535382
The silverware basket, used for dishwashers, is in the bottom dishrack. The lower dishrack basket is used to hold eating utensils such as spoons, forks, and knives, and other small tools. If the basket in the dishwasher is worn out or the basket is broken, replacing it can be a solution. No tools for this replacement are required, as it is an easy process. If you need further guidance refer to the instructions provided by the manufacturer. For safety precautions make sure to unplug the dishwasher and wear gloves.
Heating Element Brass Nut – Part Number: 154106202
$16.03
In Stock
Heating Element Brass Nut
★★★★★
★★★★★
(9)
Part #154106202
The heating element nut is used to connect the heating element to the dishwasher tub. If water is leaking from underneath your dishwasher, you may need to tighten or replace the heating element nut. Replacing the nut is an easy job, does not require any specialty tools, and should not take you more than 10 minutes. For our step by step guide, click the video below. The brass nut measures 7 inches in length x 1 inch in width x 5 inches in height, and fits most dishwashers. To see if this part is compatible with your dishwasher, check the list of compatible brands below.
Temperature Sensor – Part Number: 316490000
$57.15
In Stock
Temperature Sensor
★★★★★
★★★★★
(53)
Part #316490000
This genuine OEM oven probe is also known as an oven temperature sensor or range probe. This part is manufactured for a range, stove, or oven to detect the temperature within the oven cavity. The probe allows the oven to maintain the set temperature by sensing the temperature and sending the information to the ovens motherboard. You may need to replace this part if oven is not heating or is heating unevenly. Be sure to disconnect power to oven before replacing, as it is an electrical part. Tools needed are 1/4 inch nut driver and needle nose pliers.
Lower Spray Arm – Part Number: 5304507158
$54.47
In Stock
Lower Spray Arm
★★★★★
★★★★★
(58)
Part #5304507158
This lower dishwasher spray arm assembly is designed to distribute pressurized water across the lower rack, helping ensure thorough and consistent cleaning of dishes during each wash cycle. Engineered for smooth rotation and wide spray coverage, it directs water efficiently to remove food residue and buildup, even on heavily soiled items. Made from durable, heat-resistant materials, the spray arm withstands high temperatures and regular water pressure while maintaining reliable performance. Replacement is recommended if the existing spray arm is cracked, clogged, loose, or causing poor cleaning results, unusual noises, or reduced water flow. Installation is quick and tool-free, making it an easy solution for restoring proper wash performance and overall dishwasher efficiency.
SUPPORT – Part Number: 5304532235
$13.10
In Stock
SUPPORT
★★★★★
★★★★★
(20)
Part #5304532235
This part is a replacement spray arm support for your dishwasher. It is made of white plastic and is approximately 3 inches long, 1 inch wide, and 3 inches tall. This is the support for the lower spray arm and is found at the bottom of the dishwasher. The lower spray arm spins on the support when the dishwasher is running. If the support is cracked or broken, the spray arm may not spin, and your dishes will not be cleaned properly. You may also notice that your dishwasher is noisy when it runs; this can mean the arm support is damaged as well.
Light Bulb – Part Number: 316538904
$27.45
In Stock
Light Bulb
★★★★★
★★★★★
(13)
Part #316538904
This OEM 40 watt appliance light bulb is used for some ranges, refrigerators, freezers, and microwaves. Simply locate the existing bulb, unscrew it from its socket, and replace with new light bulb. If the existing bulb is broken in the socket, disconnect the power to the refrigerator and use a pair of needle nose pliers to grip the internal fragments of the bulb to unscrew. Replace with the new bulb and reconnect the power to the refrigerator. These bulbs are sold individually and are a commonly replaced part; consider ordering a spare.

Exact Part matches for your search term

LATCH MECHANISM – Part Number: 8046
No Longer Available
LATCH MECHANISM
This part number matches the current model number 8046
Part #8046
DISCONTINUED – Part Number: 8046
No Longer Available
DISCONTINUED
This part number matches the current model number 8046
Part #8046
Angle side top – Part Number: 8046
No Longer Available
Angle side top
This part number matches the current model number 8046
Part #8046

Common Symptoms of models starting with 8046

How this model fails, and the parts that fix it.

Watch our pros, then fix it yourself.

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Oven woudn't heat
1298 of 1510 people found this instruction helpful.
  • David from Shawnee, KS
  • Really Easy
  • Less than 15 mins
  • Screw drivers
1. Removed two screws, pulled out the element, voltage tested the element and determined it was an open circuit (bad element).
2. Ordered the part from partselect.com
3. Disconnected element, connected the new one, and screwed it back in.
Was this helpful?
Thank you for voting!
The spray arm would fall off during the washing cycle.
827 of 844 people found this instruction helpful.
  • Roy from Worcester, MA
  • Really Easy
  • Less than 15 mins
Repair was simple. I unscrewed the old grommet which held the old spray arm and screwed-on the new one. About 30 seconds was required. Other people having this problem should note that the spray-arm is made of three pieces which are inseparable when the arm is new. The arm is sold in this form. However, when your machine is having th e problem that the arm falls off, the three pieces become separate. When you want to replace the spray arm, only one new part needs to be ordered because this part encompases all three components.
Was this helpful?
Thank you for voting!
Element cracked in two pieces
821 of 928 people found this instruction helpful.
  • Michael from Green Bay, WI
  • Really Easy
  • Less than 15 mins
  • Nutdriver
Shut off circuit breaker to stove and collected the tool from the basement. Turned on flashlight. Unscrewed the two hex nuts from the old element/back of the oven. Slid the old element prongs out of the back, exposing the connecting wires. Pulled the connecting wires off of the old element, carefully, so that the connections wouldn 't come off of the wires. Threw the old element pieces in the garbage. Connected the new element to the connecting wires and re-fastened the hex nuts. My husband had wanted to call the repair man, but it didn't look too difficult, so I decided to try it on my own. Boy was he surprised when I fixed it, and for a fraction of the cost of hiring a repairman! Ladies, we can do this ourselves!!! :) Thank you for being there for us to order our part from, Parts Select, we had our new part in less than 24 hours, so the shipping was blazing fast!!! Keep up the good work!!! :)
Was this helpful?
Thank you for voting!