8045 - Parts

This is an authentic Snapper replacement part manufactured for use with walk-behind lawnmowers. This special cable has fittings at each end to connect with the control bail and engine. The cable is used to operate the mower while the bail is pressed, then turns the engine off when released. This cable is sold as an individual replacement part.

It is an authentic OEM item that is designed for use with a variety of lawn and garden equipment. A washer is a special part which helps to provide a tight fit between connected components. This part provides an identical replacement for a damaged or a missing hardware that was installed on a new unit. It is a standard hardware which may ...Read morehave multiple applications. Make sure to check the appropriate diagrams for your specific model for the exact location and the correct application of this cone washer. Note, it is made of durable metal and is sold individually.

This is an authentic Snapper replacement part, sourced from the original manufacturer for use with lawnmowers. The special gasket is commonly used to seal the connection between the two halves of the gearcase housing assembly. This gasket housing is available as an individual replacement part, please see model diagram for associative parts.

This is genuine OEM sourced part and is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is an identical replacement for a missing or damaged spring that was originally installed on a new unit. The purpose of this hardware is to apply tension on the exhaust and intake valves. ...Read moreMake sure to refer to the owners manual and the appropriate diagrams of your model for the correct installation of this component. This high-quality spring is made of durable metal and is sold individually. To replace it, you will need to unscrew and remove the cylinder head. This will allow you to take out the valve and replace the spring.

This replacement muffler/shield assembly is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines that are commonly installed on lawn and garden equipment. The purpose of a muffler is to reduce the noise from the engine's exhaust. Over time it may wear out and it can get clogged eventually req...Read moreuiring a replacement to ensure engine's peak performance. It is a high-quality metal body component which is sold individually. A small wrench will be needed to perform this repair.

This is a genuine replacement part manufactured for use with outdoor power equipment. The special nut is used with a variety of types of equipment and the application of the nut varies depending on the model of equipment. This nut is available as an individual replacement part, please see model diagram for the nut\'s location and usage.

It is an authentic OEM sourced item which is specially produced for use with snowthrowers, generators, and rear engine riders made by Murray, Briggs & Stratton, Snapper, and Simplicity. The nut is made of metal and attaches to the starter switch. During replacement, it may require a wrench to help install this part correctly. It may becom...Read moree broken or stripped and will need to be replaced. This part is available as an individual replacement.

The retainer attaches to the idler arm support. This genuine item is supplied by the original equipment manufacturer for use with tractors and rear engine riders made by Snapper, Murray, and Simplicity. It is made out of metal and is sold individually. During the installation process, a wrench set might be needed to replace this part. Over time this part may break and will need to be replaced.

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Snapper lawn mowers. The wheels allow you to easily propel your mower from place to place. This part is made out of plastic and rubber and is also sold individually. Before installation, make sure the engine has cooled, and disconnect...Read more the wire and boot from the spark plug. For installation, you will need a socket wrench.

This is an authentic replacement part manufactured for use with Briggs & Stratton small engines. The idle mixture kit is used to adjust the amount of fuel that is sent to the engine's intake while the engine is idling. This idle mixture kit is available as an individual replacement part.