8039 - Parts

Bezel

This is an authentic Briggs & Stratton replacement part that is intended to be used with small engines. The rings are used with the oil to seal the connection between the piston and the inner wall of the cylinder. This seal separates the combustion chamber and the crankcase to maintain compression. This ring set includes three rings to be sued with one piston.

This is a genuine Snapper replacement part. The steering shaft is designed by the manufacturer for use in lawn tractors. This part is made of metal, and is used to connect the steering wheel with the steering support and sector gear assemblies. You may require a wrench when replacing this item. This part is sold individually.

This 0.25-inch-diameter washer with internal lock teeth is an authentic manufacturer replacement fastener used in outdoor power equipment. It has a flanged base, which provides even load distribution and protects the mounting surface from damage during installation and removal. The washer also has inward-facing teeth, providing additional...Read more grip to prevent the secured components from falling off the equipment. Over time, the washer will corrode, crack, or wear down its teeth, leading to equipment instability, noise, and vibrations. Inspect all the washers in your equipment and replace those that are no longer functional. Use a wrench or socket to loosen and remove the old washer, and then position the new one on the mounting surface. Tighten the washer until the flange rests flush against the surface. Each washer is sold individually.

This is a genuine replacement part sourced directly from the manufacturer. The straight lube fitting is commonly found in riding mowers and snowblowers from Snapper and Murray. This part is made of metal, and is generally placed in the hub of the wheel assembly to allow the axle to be lubricated. This item is sold as an individual replacement part.

This is an original Snapper replacement part. The spindle housing is designed by the manufacturer for use in lawn tractors. This part is made of metal, and is used to hold the spindle that powers the mower blade. You will require a wrench when replacing this item. This part is sold individually.